Steelcase 9000 Series User manual

Page 1 of 3
939500917 Rev B
Series 9000 Conventional Panel Stabilizer Foot
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2001 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
3/16”
1/4” BIT
For Use On Convention Panels Only.
Caution: The stabilizer foot is used to stabilize a run of
panels only and is not to be used to support a run of
panels with over hung loads from hang-on components.
Failure to do so may result in personal injury.
Panel stabilizer foot
must not be used as the sole
source of support for panels.

Page 2 of 3
939500917 Rev B
1/2” PROTECTIVE PAD
9 1/4”
1. Remove base trim by pushing down
 on spring tabs and lifting up and out.





2. Locate and drill a 1/4" dia. hole thru
 both flanges of the bottom pan.
NOTE: Use a protective pad under
 bottom pan before drilling.













3. Remove two (2) screws from bottom
 of stabilizer foot and attach foot bracket.

Page 3 of 3
939500917 Rev B
#10 Phillips Head Screw
4. Install foot bracket under bottom pan
 using #10 phillips head screw.











5. Replace base trim. Rotate stabilizer foot
 into position and engage hooks of the
 stabilizer foot into panel upright. Some
 vertical adjustment of hooks may be
 required. The adjustment is made by
 turning screw, (located under access
 hole) with allen wrench. Adjust screw
 clockwise until stabilizer foot lowers
 and seats firmly against the floor.
Note: Over tightening adjusting screw will raise the panel
from the floor and result in unstable conditions.
Note: When your panel is not supported with adjoining
furniture or another panel secured at an angle, it is
necessary to use two (2) feet as shown above.