Steelcase Details eyesite FPAEC2CC User manual

eyesite™dual monitor support
Installation Instructions 19716201 Rev A
FPAC2CC FPAEC2CC
FPAC2TM FPAEC2TM
FPAC2CS FPAEC2CS
Eyesiite™|Installation Instructions
A Steelcase Company
CLAMP
BRACKET
BOTTOM
BRACKET BOLT
BUTTON HEAD
SCREW
WORKSURFACE
PLATE
C-clamp Mount Installation
DRILLED HOLE
PLATE
NUT
WORKSURFACE
Through Mount Installation - Drill 3⁄8" 24 - 30" from front of worksurface edge
1a 1b 1c 1d
1a 1b
BASE
BRACKET
PLASTIC COVER
SCREW
CLAMPING
BRACKET
BRACE
SCREW
1a 1b 1c
1d 1e
Must seat
in the lower
c:scape Rail
groove.
c:scape™Mount Installation
Tools required:
#2 Phillips Screwdriver
Power Drill
3⁄8" Drill Bit
5⁄32" Allen rench
Provided
Page 1 of 2
5⁄16" Box End rench

For a better day at work.
®A Steelcase Company
©2009 Steelcase Inc. All rights reserved. 11/09
COLUMN
COLUMN
COLUMN SLOT
MONITOR MOUNT
BRACKET ASSEMBLY
TOOTH
MONITOR
MOUNT
BRACKET
ASSEMBLY
COLUMN
TOOTH
Installation Instructions:
COLUMN
MONITOR MOUNT
BRACKET ASSEMBLY
4a
PROVIDED
ALLEN WRENCH
ADJUSTMENT
SCREW
MONITOR
MOUNT
ASSEMBLY
MONITOR
MOUNT
BRACKET
ASSEMBLY
MONITOR MOUNT
ASSEMBLY
SCREW
SET SCREW
ALLENWRENCH
MONITOR
TILT BRACKET
ADJUSTMENT
SCREW
Adjust height with Drill or Allen rench Route CablesAdjust Handle
2a 2b 2c 2d
3a 4a 4b
Align Screens
NOTE: Secure Yolk to the Column.
NOTE: Install Tooth shown into top slot.
Recommendation: Adjust the height of the Flat Panel Monitor Support
so that the center of VESA bracket is 46" above the floor.
Page 2 of 2