Steelcase Avenir IBM User manual

Page 1 of 3
939501507 Rev A
Avenir®Brackets - IBM and DEC Amp Mounting Bracket
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2004 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
ELECTIVE ELEMENTS
BRACKET (NON-HANDED)
HANGER BRACKET
(LH SHOWN - RH TYPICAL) HANGER BRACKET
(LH SHOWN - RH TYPICAL)
“AMP” MOUNTING
BRACKET “AMP” FLEXMODE
MODULE KIT
“DEC” CABLE
CONNECT BOX
“IBM” CABLE
CONNECT BOX
CAUTION: For communication cables only. Not
intended for power supply cords or electrical wiring.

Page 2 of 3
939501507 Rev A
1a.
“IBM” CABLE CONNECT BOX
1a. Secure right or left hand bracket to
back of cable connect box with (2) screws
and hex nuts.
“DEC” CABLE CONNECT BOX
1b. Secure right or left hand bracket to
back of cable connect box with (2) wood
screws.
2. Hold cable connect box in a vertical
position and insert tabs onto slots on panel
uprights. Push down engaging tabs into
slots.
2.
1b.
SERIES 9000
VALENCIA
MOVABLE WALLS
ELECTIVE ELEMENTS
BRACKET (NOT HANDED)
IBM CABLE
CONNECT BOX
HEX NUT
#10-24
DEC CABLE
CONNECT BOX
HANGER BRACKET
(LH SHOWN - RH TYPICAL)
WOOD SCREW
#8 x 1/2”
SCREW
#10-24 x 5/8”
HANGER BRACKET
(LH SHOWN - RH TYPICAL)
TYPICAL PANEL
ASSEMBLY
CABLE
CONNECT
BOX

Page 3 of 3
939501507 Rev A
2.
1.
CAUTION: Do not obstruct label adhered to bottom of channel!
INSTALLATION OF “AMP” MOUNTING
BRACKET INTO ENERGY MANAGE-
MENT CHANNEL
1. Install “AMP” flexmode module kit into bracket
and wire back of connectors.
2. Clip “AMP” mounting bracket into cutout, at the
bottom of energy management channel, (either end).
“AMP” MOUNTING
BRACKET
“AMP” FLEXMODE
MODULE KIT
“AMP” MOUNTING BRACKET
WITH “AMP” FLEXMODE MODULE
KIT INSTALLED ENERGY MANAGEMENT
CUTOUT