Stepper Motor Canada DB25-1205F User manual

Model#-DB25-1205F
6 Axis CNC Interface Breakout Board
Manual
www.StepperMotorCanada.ca
R making connections toead this manual carefully before the board.
this manual away for further reference.Store

Safety Notes:
The control board is DC powerelectronics of the designed to accept ONLY.
Ensure connections are made correctly that the positive and negative before
ing the unit. Incorrect wiring will cause damage to the board.power on
an open circuit design. D allow The control board is o not conductive objects
such as pieces of wire stray pieces of to touch any of part of small or metal
the circuit Mount inside an inclosure using insulated (plastic) stand offs or .
insulating pads. Do not mount directly to any conductive metal or aluminum
plates. Handle with care, do not drop or touch the electronic parts on the board.
Keep the board from damp environment.
Keep the board in adequate ventilation.
Keep the board from mechanical damage.
Note: the DB25-1205F, has a female 25 pin line printer port input to be used
with a male parallel printer cable.
It can not be used with serial printer cables, usb to serial printer cord adapters,
or any other cable that is not a parallel printer cable .
If your computer does not come with a DB25 parallel printer port, one may be
installed.
To avoid frustration be sure you have the right cable.
www.StepperMotorCanada.ca
Model#-DB25-1205F

DB 25 Female Connector
Power In
+5V
GND
GND
+5V
P17 P16 P1 P14 P9 P8 P7 P6 P5 P4 P3 P2
Signal Inputs
P13
P12
P11
P10
P15
GND
Signal Outputs
www.StepperMotorCanada.ca
P2 is for X axis pulse, P3 is for X a is directionx
P4 is for Y axis pulse, P5 is for Y axis direction
P6 is for Z axis pulse, P7 is for Z axis direction
Other 3 axis can be setting as
P8 is for A axis pulse, P9 is for A aixs direction
P14 is for B axis pulse,P1 is for B axis direction
P16 is for C axis pulse,and P17 is for C axis direction
DB 25 Male Connector
Model#-DB25-1205F

Jn1 and JN2 are connected in the case of a single power supply.
The +5V and the isolating source (+) will be connected.
The GND and the isolating source (GND) will be connected.
If JN1 and JN2 is not connected (open)
The +5V and the isolating source (+) will NOT be connected.
The GND and the isolating source (GND) will NOT be connected
www.StepperMotorCanada.ca
J4 is the isolating source (GND) and Isolating source(+)
The power supply input port, it can set up the single or double power supply.
Model#-DB25-1205F
J1 is the contact pin output.
It is the same as signal outputs P2 - P7
Designed to be used with 6 pin connector
for small drivers.

www.StepperMotorCanada.ca
Signal Inputs
GND
P15
P10
P11
P12
P13
Emergency stop
Limit switch etc.
Model#-DB25-1205F
END
Signal inputs P10 - P15 can connect to a sensor or switch.
The inputs then can be recognized by the software.
Example of connection:
P10 Emergency Stop
P11 Tool Setting
P12 X axis limit switch
P13 Y axis limit switch
P15 Z axis limit switch