STI STI-1215 User manual

Toll Free: 800-888-4784 • E-mail: [e-mail]
Web: www.sti-usa.com
Tel: [phone] Fax: [phone]
E-mail: [e-mail] • Web: www.sti-emea.com
USA - Headquarters
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: [phone] • Fax: [phone]
European Office
Taylor House • 34 Sherwood Road • Bromsgrove
Worcestershire • B60 3DR • England
INSTALLATION OF STI-1217 STOPPER DOME FOR HORN/SPEAKER/STROBE
All specifications and information shown were current as of publication and are subject to change without notice.
INSTALLATION NOTES
1. To minimize strobe light loss, regardless of the type of horn/strobe appliance used, the clear
section (not the section containing the cutout slots) must be centered over the strobe light
lens. Failure to follow these instructions may lead to light loss transmission.
2. Stopper Dome must be installed to comply with applicable NEC, NFPA and local codes.
3. Stopper Dome may be installed outdoors when appliance carries an outdoor rating.
4. If added protection is needed due to environmental conditions, order SUB-123 Enviro kit.
Three year warranty or a one year limited warranty (from
date of purchase) on most products. See website for details.
Electronic warranty form at www.sti-usa.com/wc14.
1217IS JAN2017
CLEANING INSTRUCTIONS
Rinse with water to remove abrasive dust and dirt. Wash with soap
or mild detergent, using a soft cloth (do not scrub). Rinse once
more then dry with a soft cloth or chamois. To remove grease or
wet paint, rub gently with a cloth wetted with naphtha. Then wash
and rinse. DO NOT USE RAZORBLADES.
INSTALLATION INSTRUCTIONS - REFER TO EXPLODED VIEW
1. Using enclosure assembly as a template, place against
mounting surface at proper location accordingto NFPA 72.
2. Mark and drill (4) holes 1/4 in. (6.3mm) diameter, 1 in.
(25mm) deep.
3. Insert the (4) rawl plugs into the wall.
4. Mount frame assembly to wall with screws.
5. Install electrical fittings as needed.
6. Install horn/strobe appliance (except for retrofit applications).
7. Install cover with clips and screws.
8. Test appliance accordingto appliance manufacturer’s
instructions.
PLASTIC INSERT
(1) PROVIDED
CONDUIT SEALING GASKET
SUB-123 ENVIRO KIT
ADHESIVE BACKED GASKET
SPACER TO MOUNTING SURFACE
EXISTING
WARNING
APPLIANCE
RAWL PLUG
(4) PROVIDED
01212 SPACER
SCREW
#10 x 1-1/2 in.
(4) PROVIDED
GASKET
(COVER TO SPACER)
01215 HORN/STROBE
PROTECTIVE COVER
WASHER (6) PROVIDED
#8 - 32 x 3/8 in.
SOCKET HEAD CAP SCREW
(6) PROVIDED
IF ADDED PROTECTION IS NEEDED
DUE TO ENVIROMENTAL CONDITIONS
ORDER SUB-123 ENVIRO KIT
ALSO INCLUDES (6)
#8-32 X 3/4 in. SOCKET CAP SCREWS
2.87 in.(73mm)
7.87 in.(200mm)
1.62 in.(41mm)
7.37 in.(187mm)
STI-1215
COVER
STI-1212
SPACER
REMARQUES SUR L’INSTALLATION
1. Afin de minimiser la perte de lumière stroboscopique,quel que soit le type d’alarme sonore/de
stroboscopeutilisé, la section dégagée (et NON la section contenant les fentes de découpe), doit
être centrée sur l’objectif stroboscopique.Le fait d’omettre ces instructions risque d’entraîner la
perte de diusion de la lumière.
2. Le dôme Stopper doit être installé de sorte à être conforme avec les normes NEC, NFPA applicables
et les codes locaux.
3. Il est possible d’installer un dôme Stopper à l’extérieur lorsque l’appareil est homologué pour
utilisation à l’extérieur.
4. S’il est nécessaire d’ajouter une autre protectionen raison des conditionsenvironnementales,
commandez la trousse Enviro, SUB-123.
PRODUCT DIMENSIONS

UL INSTALLATION REQUIREMENTS
STI DOME SERIES
• The enclosure is rated to protect signaling appliances indoors and in areas of indirect weather
exposure. The cover may be used outdoors only with devices also suitable for outdoor use.
• When covering fire-signaling appliances with this enclosure, some light and sound loss
occurs. Please follow the guidelines listed during installation.
• Strobe light loss values for respective manufacturers are shown below. To determine the
new composite candela value for use with this guard refer to the sample calculation shown
below for a manufacturer’s strobe.
• Example: Record the manufacturer's candela value as "A" and the light loss value as "B" and
the assembly value as "C". For example “Sample Company” has a 60 candela strobe with a
30% light transmission loss value. Value "A" is now 60. Value "B" is (60 times 30% or 0.30)
in this case 18. Now value "C" equals value "A" minus value "B" or 60-18 = 42 candela light
source. Now refer to NFPA tables for proper room size that the newly established value "C"
will work in. Submittal installation drawings must show the composite candela value as 42.
• On a dual value strobe such as 15/75 a calculation must be done for each value and the
drawing notation composite value for each number on the strobe.
CAUTION:
Performance Review - LIGHT DERATING FACTOR
+ Indicates notification appliance can also be used with STI Heater Domes models STI-1229HTR or STI-1229HTR240
SOUND DERATING FACTOR for STI-1215, STI-1217, STI-1219
HORNS: Amseco Audible Horn Sounders: 6.2 dBA; System Sensor: 3.1 dBA
SPEAKERS: Siemens Adapter Series (0.5, 1, or 2 watt taps only): 4.1 dBA
USA Headquarters •2306 Airport Road •Waterfood •Michigan •48327-1209 •Phone: [phone] •Fax: [phone] •www.sti-usa.com
European Oce •Taylor House •34 Sherwood Road •Bromsgrove •Worcestershire •B60 3DR •Phone: [phone] •www.sti-europe.com
Manufacturer
Series
STI-1215/
1217/1219
STI-1225/
1227/1229
Manufacturer
Series
STI-1215/
1217/1219
STI-1225/
1227/1229
ADT SECURITY
ADTG1-VSeries
20%
32%
HONEYWELL
XLS202 Series
33%
34%+
AMSECO
SL24W-153075
22%
37%+
HONEYWELL
XLSG1-HVSeries
20%
32%+
AMSECO – COLORED LENSES
SL24W-15307 A,B,G or R
22%
37%+
HONEYWELL
XLSG1-HOV Series
20%
37%+
AMSECO – COLORED LENSES
SL24C-15307 A,B,G or R
22%
37%+
MIRCOM
FS-240
22%
37%+
AMSECO – COLORED LENSES
CSL24W-A,B,G or R
22%
37%+
MIRCOM
MS Series
33%
34%+
AMSECO – COLORED LENSES
CSL24C-A,B,G or R
22%
37%+
MIRCOM
MG1-VSeries
20%
32%+
DETECTION SYSTEMS
GES24 Series
27%
37%+
MIRCOM
MG1-HVSeries
20%
32%+
DETECTION SYSTEMS
GES24-15/75
27%
37%+
MIRCOM
MG1-HOV Series
20%
32%+
EST/EDWARDS
2440S Series
33%
34%+
MIRTONE
MG1-VSeries
20%
32%+
EST/EDWARDS
202 Series
33%
34%+
NATIONAL TIME&SIGNAL
GES24 Series
27%
37%+
EST/EDWARDS
G1-VSeries
20%
32%+
NATIONAL TIME&SIGNAL
GES24-15/75
27%
37%+
EST/EDWARDS
G1-HVSeries
20%
32%+
POTTER ELECTRIC
AS-24-153075R
22%
37%+
EST/EDWARDS
G1-HOV Series
20%
32%+
POTTER ELECTRIC
AS-24-153075W
22%
37%+
EST/EDWARDS
EG1-VSeries
20%
32%+
SECUTRON
GES24 Series
27%
37%+
EST/EDWARDS
EG1-HVSeries
20%
32%+
SECUTRON
GES24-15/75
27%
37%+
EST/EDWARDS
EG1-HOV Series
20%
32%+
SIEMENS
202 Series
33%
34%+
FARADAY LLC
2700
23%
33%+
SIEMENS
G1-VSeries
20%
32%+
GETEX
GES24 Series
27%
37%+
SIEMENS
U-MCS Series
23%
33%+
GENTEX
GES24-15/75
27%
37%+
SYSTEM SENSOR
SS24110ADA
26%
36%+
HARRINGTON SIGNAL
GES24 Series
27%
37%+
SYSTEM SENSOR
P2,PC2,P4,PC4,SX,SC
39%
28%
HARRINGTON SIGNAL
GES24-15/75
27%
37%+
WHEELOCK
RSS-24MCW
34%
31%
HONEYWELL
XLSG1-VSeries
20%
32%+
WHEELOCK
RSS-24MCC
36%
35%
ZITON PTY LTD
ZG1-VSeries
20%
32%+