STK Professional Audio SYNC5.5 Troubleshooting guide

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 1 16/07/2015 17:45:20

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 2 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 3 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 4 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 5 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 6 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 7 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 8 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 9 16/07/2015 17:45:21

STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 10 16/07/2015 17:45:21

AT BE CY CZ DK EE FI FR
MT NL PL PT SK SI ES SE
DE GR HU IE IT LV LT LU
GB IS LI NO CH BG TO TR
STKSYNC55-QUG-EN-ES-FR-IT-RO-HU-BG-SR-PL-16072015-OUTLINED.indd 11 16/07/2015 17:45:21

FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user'sAny Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:
This Phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that
were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device
types: Sync 5.5( FCC ID: 2AE7RSANTOKSYNC55 ) has also been tested against this SAR limit.The highest SAR value reported
under this standard during product certification for use at the ear is 0.33W/kg and when properly worn on the body is 0.88W/kg. under this standard during product certification for use at the ear is 0.33W/kg and when properly worn on the body is 0.88W/kg.
This device was tested for typical body-worn operations with the back of the handset kept 1.0cm from the body. To maintain
compliance with FCC RF exposure requirements, use accessories that maintain a 1.0cm separation distance between the user's
body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components
in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements,
and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separationThis device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation
distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips,
holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do
not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an
approved antenna.