
Too long
(Velcro not on fabric)
Perfect! Too short
Apply Boot to Either Foot
Check the Strap Length
Cleaning Sensor and Boot
Remove the sensor and place just the boot (and the straps if desired) in the washing machine.
Insert the sensor at
an angle, toe end first.
Insert Sensor Into Small Boot
Remove Sensor
Do not put the sensor
in the washing machine
To remove the sensor, push it from the
opening at the bottom of the boot.
Press down to secure the
sensor. The sensor should
sit flush in the boot.
Boot and sensor maintenance
Sensor
Zone
Top Sensor
Bottom Sensor
Strap Tightness
The sensor strap should sit
flush against the top of the
foot, with no gap.
The ankle strap should be
snug but not tight.
Boot Sizing (Using Small Boot As Example)
IMPORTANT NOTE
Make sure all sensors are making good contact with
the baby’s skin to ensure correct measurement.
OWNER’S MANUAL
Refer to the online manual for other functions,
information, and operation details.
masimostork.com/vitals-plus-user-manual
© 2023 Masimo. All rights reserved. 304451/11962A-0523
Dampen a cloth with water to wipe the
components of the Stork System (sensor
is shown in the example). Bleach wipes or
70% isopropyl alcohol can also be used.
Do not use household cleaning agents.
OK
OK for toes to
overhang - boot
DOES NOT fit like
a typical shoe.