StowAway 2 025.41 User manual

StowAway Rod Holder Instructions (025.41):
Package Includes:
www.StowAway2.com
800-943-5377
Rev. 1114
6 - Round Washers
6 - Nuts
6 -
Bolts
Tools Needed:
•Phillips Screwdriver
• 7/16" Socket or Wrench
•3 - Rod Tubes
•1 - Inside Bracket
•1 - Outside Bracket
•3 - Oval Washers

StowAway Rod Holder Instructions:
1. Position a tube against the outside bracket (A), with the
larger mounting holes away from the bracket. Push a bolt
through the outer hole, oval washer, inner hole, and bracket
as shown. Cut the wire tie holding the oval washer and insert
the second bolt through the matching holes as above.
2. Position the outside bracket and tube against the cargo
rack railing. Place the inside half of the rod holder bracket
against the railing so that the bolts go through the inside
bracket (B). Add nut and washer and tighten lightly.
3. Install the two remaining tubes, repeating steps 1 & 2
above.
4. Position the rod holder at the desired angle and location,
and fully tighten all hardware.