
Please read and understand these instructions before any use of this
product and retain for future reference.
NOTICE: To prevent blowing a fusible
link on the Power Socket, only use with
15 Amp rated Power Socket receptacle.
1. Place the Power Switch in the O (off)
position. Plug the 12V Power Socket
into the vehicle's 12V Power Socket
receptacle.
2. The Heater can be removed from the
Mounting Base. By holding the Handle
and sliding it off the base plate.
The Heater can be moved around as
needed on the ball and socket joint.
3. To operate, press the Power
Switch to Ior II depending on
the strength of the heat required.
Toggle the Power Switch to the
center position to turn off (O).
WARNING! Do not operate longer
than 15 minutes at one time, allow
heater to cool completely after use.
4. Unplug the Heater before
leaving the vehicle.
12 Volt
Heater & Defroster
SWCH500 Manual AW (Rev) 2018.qxp_Layout 1 20/07/2018 11:23 Page 1