
3
You will need to thread your vehicle’s seat belt through the hooks as per instructions below:
1. Fasten the seatbelt as shown in Figure 1. You will need to fasten the seatbelt to the
clip of the opposite rear seat. This provides enough width of the seat belt.
2. To secure the pet kennel, use the kennel’s two spring hooks, located on the bottom
of the kennel, to secure the kennel to your vehicle’s rear seatbelt. See Figure 2.
Figure 3 shows kennel on the other side.
IMPORTANT: It is illegal to drive with a pet carrier/kennel that is not properly
secured into your vehicle’s seat. It is important that you utilise your vehicle’s
seat belt to secure this product in place.
For the health & safety of your pet that is inside the kennel, please close and zip up all the
panels before driving.
IMPORTANT: Always close and zip up all the panels of this kennel when driving with
your pet inside the kennel.
Securing The Carrier To Your Vehicle
When Driving With Your Pet Inside The Kennel
PLEASE NOTE: Do not secure the carrier to your vehicle with your pet inside
the carrier. The carrier must be empty.
Fig 1 Fig 2 Fig 2
After Use
Once you have finished using the product, please reverse the steps outlined in
the assembly instructions. Please note, when folding the kennel, you will need
to twist the kennel and press downwards to fold. On doing so, you will need to
ensure both spring hooks and circular hooks align on either side so you can
secure them in place.