structura Duo Bollard User manual

Duo Bollard
Installation Instructions
Warnings
CAUTION—risk of fire and this product must
be installed in accordance with the applicable
installation code by a person familiar with the
construction and operation of the product and the
hazards involved.
Suitable for wet locations.
Mounting orientation must have light source facing
down.
Electrical service must be disconnected during
installation.
Proper grounding is required to protect against
shock and proper operation.
Tools Required
T20 Tamper-resistant drive for panel screws
9/16” socket or wrench for anchor bolts
Philips drive for driver box lid
Wiring tools and connectors
Bollard Installation
Step 1: Remove (4) 8-32 tamper-resistant torx screws
from from lower accent panel. Set panel aside.
Step 2: Pull driver box out of bollard base and
connect power to LED driver. See page 2 for driver
box wiring.
Step 3: Set bollard on to pre-installed anchor bolts.
Make sure baseplate is level.
Step 4: Secure bollard with supplied (4) 3/8”-16 nuts
and washers.
Step 5: Place driver box back into base cavity.
Step 6: Resecure accent panel.
19922 W. 162nd St., Olathe, KS 66062 913.390.8787 www.structura.com
Driver Box
LED Module
8-32 Tamper-Resistant Torx
Accent Panel
3/8"-16 Nut

Duo Bollard
Installation Instructions
Bollard Wiring
Step 1: Take off driver box lid by removing (4) Philips
screws.
Step 2: Connect input power to driver pigtail as
shown above.
Step 3: Connect dimming wires to remote dimmer
(by others) if applicable.
Step 4: Connect grounding wire to ground pigtail
attached to driver box tray.
Step 5: Resecure driver box lid and reinsert back into
bollard base.
19922 W. 162nd St., Olathe, KS 66062 913.390.8787 www.structura.com
LED Module
AC/N (White)
AC/L (Black)
Input
100-240/277V 24V
Dim+ (Purple)
Dim- (Grey)
Ground
Connected
to Driver Box
1.5"
8"
4.5"
4.5"