Volt 390 Series User manual

VOLT®Low Voltage Landscape Lighting
Traditions Path & Area Light
390 Series
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2014, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm

VOLT® Traditions Path & Area Light
390 Series
Important: Please Read Before Installation
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
!
!
www.voltlighting.com
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage
lamp.
6. Do not operate the luminaire tting with a missing or damage shield.
SAVE THESE INSTRUCTIONS
This luminaire is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and in-
structions may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, opera-
tion maintenance or mounting situation.
1. Make sure that the power is turned OFF before installing or servicing
this luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply (trans-
former) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that is suitable
for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or t-
ting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm)
7. If additional lengths of low voltage cable is required, please contact
www.voltlighting.com or call 1-813-978-3700.

[e-mail] • 813.978.3700
Package Contents
A. (1) Luminaire
B. (1) Tempered Glass
C. (3) Lock Ball
Product Dimensions
Install Stake
1
Determine desired location for mounting
luminaire. Hammer stake into ground until
ange of stake is ush to grade. To avoid dam-
age to stake, place board on top of stake while
hammering.
NOTE: If ground is hard and stake is difcult
to install, make a crosscut in ground using a
at shovel.
Board
Stake
Soil
Ground
23”
11”
51/2”
4”

INSTALLATION INSTRUCTIONS
www.voltlighting.com
VOLT® Traditions Path & Area Light
390 Series
Install Tempered Glass
3
Attach tempered glass over bolts in the
shade and secure with lock balls.
Lock Ball
Bolt
Shade
Tempered Glass
Insert lamp, sold separately, with correct wattage
and type as marked on luminaire label.
CAUTION: Do not exceed maximum wattage
marked on luminaire label.
NOTE: DO NOT TOUCH halogen lamp with
bare hands. Use soft cloth to handle lamp.
Install Lamp
2
Lamp
Socket

Install Luminaire to Stake
4
Clear away area in ground at wireway
slot in top of stake. Lay luminaire pig-
tail into wireway slot and screw stem
into stake.
If assembly does not look straight,
adjust by pushing or pulling on stake
only.
Use bubble level against side of stem
to ensure that stem is perpendicular
to ground.
Pigtail
Rod
Stake
Wireway Slot
[e-mail] • 813.978.3700
Wire Connections
5
Strip two leads from luminaire pigtail. Using two wire connectors, not
provided, connect leads from luminaire to main low voltage supply cable
lead.
Luminaire Wires
Main Low Voltage
Supply Cable
Wire Connectors
Install/Replace Lamp
Unscrew lock balls and remove tempered glass to expose lamp and replace it
with correct wattage and type marked on luminaire label. And then reinstall
tempered glass and secure with lock balls.
IMPORTANT: Halogen lamps must be protected from moisture and dust at
all times. Always re-install shade and lens when moved.

is-390-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2014, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
www.voltlighting.com
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm