Strymon sunset User manual

QUICK START GUIDE

TOP PANEL FUNCTIONS
A and B channel switches
Selects one of three circuit
options for each channel.
Ge: germanium diode circuit
with dry parallel path.
texas: single stage soft-clipper
with a mid bump.
treble: clean boost, tone knob
removes low frequencies.
2stage: soft-clipping stage
followed by hard-clipping stage.
hard: high gain single stage
hard-clipping circuit.
JFET: clean boost that subtly
beefs up and warms your signal.
LEVEL
Controls the output volume for
each channel when engaged.
DRIVE
Adjusts the amount of gain
applied to each channel.
TONE
Adjusts the treble frequencies for
each channel. The character and
response of the control varies with
the circuit type.
A and B footswitches
Toggles the channel on and o, indicated by a red LED when engaged. When
both channels are bypassed, an electromechanical relay is activated for true
bypass. See user manual for details on changing this to buered bypass.

REAR PANEL SWITCHES & CONNECTIONS
IN
Mono instrument input.
BRIGHT
Tailors the top end character of the output to match
your amp.
Config Switch
Selects the eect order for the 2
sides of Sunset. Selecting A+B will
place the eects in a parallel signal
chain.
FAV
Connect an external switch to remotely toggle
between the current settings and a saved
Favorite setting.
OUT
Mono signal out.
EXP
Use a standard TRS expression
pedal to control the output volume
of the eect (default configuration).
The EXP input can also be used to
remotely control any combination of
knobs with an Expression Pedal. See
user manual for details.
POWER
Use an adapter with the following
rating: 9VDC center negative.
250mA minimum.
Download the full Sunset manual at strymon.net/support/sunset

SAMPLE SETTINGS
Heavy Stack Blues Stack Defined Fuzz
Fat Stack Texas Classic
Dirty FET Boost Thick & Juicy Harmonic Drive

REV B
strymon.net