1. Open/Close: It opens and closes the CD tray.
2. JOG WHEEL: Use the wheel to adjust speed to match with the other playing side. It is also used for the SEARCH
and SCRATCH function.
3. CD/USB: Press to switch the source between USB and CD.
4. SCRATCH: To activate Scratch function.
5. TIME: This knob switches the display between remaining time, elapsed playing time, and total remaining time.
6. Continue/Single
CONTINUE: The unit continues to play the tracks until the end. When crossing to the next track manually or
automatically, the main cue will also renew to the new track.
SINGLE: The unit plays a single track only. When the current track ends, it crosses to the next track but stops and
renew to the main cue of the new track.
7. MEMO/AUTO: Press it for memorizing Hot Cue or activating Auto Loop.
8. Cue 1 & Cue 2: Press it for storing and playing a hot cue.
9. DISPLAY: The display is used to see which functions are playing and selected.
10. FOLDER: Press this knob to switch between MP3 folder and MP3 file. Select a folder by pressing this knob again.
• In MP3 File mode, Total-Track shows the total MP3 files in the folder.
• In MP3 Folder mode, Total-Track shows the total folders in the CD or in the USB storage device.
• When you use a hard drive as your USB play source, holding this knob down for 2 seconds
will jump to partitions.
11. PROG: In this mode the tracks can be arranged in a playlist. The maximum tracks can be edited are 99.
12. PITCH: Press it to switch the pitch range. It will switch between 8%, 16%, 100% and off mode.
13. PITCH CONTROL SLIDER: By moving the pitch control slider, you can adjust it between minimum (up) and
maximum (down) to match the beat of the two playing units.
14. RELAY: Press it to activate this function. When one unit is in play mode, and the other unit is in pause mode; pause
the playing unit, the other unit will automatically start to play.
15. SEARCH: Press the search knob to activate fast search mode. Use Jog Wheel to do the fast search forward and
backward.
16. CUE: The cue function allows the CD to be played from a memorized point.
17. SEAMLESS LOOP: There is A, B, and RELOOP knobs.
The A knob is the start point of the LOOP. The end point is knob B. Press the A and B knob to set up the point and
start the loop playback automatically. The loop lights up on the display and the three LEDs will flash.
Press B again to exit the LOOP playback.
The RELOOP knob will return to the A of the loop playback and continues playing. Also, if you want to return to
the loop playback after exiting, you can press the RELOOP knob.
Change the start and end points by pressing the A and B knobs again.
• Hot Cue: Press it to be ready to set a new cue.
• Auto Loop: Hold this knob and dial the jog wheel to preset the bar for Auto loop playback.
Then press MEMO again to let the Auto Loop mode ready. In the meantime, pressing A will automatically form an
Auto Loop playback according to the bar you select.
3
