Suicen SX-990 User manual

Please choose a proper volume when hearing the headset. It is also important
to control the hearing time for your ears health.
Pairing time exceeds 3 minutes, SX-990 will automatically shut down ;If the
headset are back to the effective distance in 3 minutes, it will automatically
reconnect with the last connected device.
When there is an incoming call, the headset will prompt: Incoming call" with
vibration. Phone number"134........."will be broadcasted. Click MFB to answer
or just operate on your mobile phone.
Press the MFB button to hang up calls, or directly hang up on your mobile phone,
it will prompt" Call ended".
When there is an incoming call, headset will broadcast the phone number with
vibration. Double click the MFB to reject or just reject it on your mobile phone, it
will prompt" Call rejected ".
Battery low
When the headset is connected with smart phone, if the distance between
device and headset is out of 10 m, headset will prompt "Device disconnected"If
comes back to the working distance within 3 min, headset will reconnect
automatically with your mobile phone. If not comes back around working
distance in 10 min, headset will power off, Please switch the button to OFF and
then to ON to wake up the headset to back to work.
Mobile phone lost indicator with headset
Double click the volume" –" when calling to have call transferred between
phone and headset.
Unlock the mobile phone and double click the volume " - " to launch the voice
dial, it will prompt" Voice Dial" , and then just speak the people's name who you
want to call, This function only works if your mobile phone support it.
SX-990
SX-990
SX-990
If the environment is potentially dangerous, please stop using the headset
Before charge this headset with charging cable, please check whether the
charge cable is original.
1. Switch the button to:"ON", the headset will turn on with vibration and
prompt "Power On" the red and blue indicator light are flashing alternately
which means the headset is entering into pairing mode and prompt" Ready
to pair".
2. Switch to "ON", it will prompt " Ready to pair " after 5 Seconds ,the red and
blue lights flash alternately when headset is ready for paring .
4. Click SX-990, Bluetooth headset gets connected with your device
automatically, and prompt" Pairing completed" and also will prompt" Device
connected" when successfully connected with SX-990. Some may require pass
code which is 0000.
charge
better
SX-990
SX-990
SX-990
BluetoothEarphonesBluetoothEarphonesSX-9BluetoothEarphonesBluetoothEarphones90BluetoothEarphones
SX-990
Bluetooth Earphones
FCC ID:UHBSX-990
Bluetooth Earphones

NOTE:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.