Summit to Sea GRAND DIVE PRO User manual

GRAND DIVE PRO

PARTS ON THE CHAMBER
FRONT
3.
4.
5.
6.
2 Blue Air
Release
Valves
Port to
connect a
cooler

PARTS ON THE CHAMBER
REAR OF CHAMBER
Port to connect a cooler
Red knob to release air
2 Auxiliary Valves if using an
oxygen concentrator
External Gauge
Internal
Gauge
2 Fill Valves

SET UP
•Lay the deflated chamber out of the floor with the open flap
facing to the front.
•Connect compressors
•Close both zippers
•Inflate chamber
•Build frame around the inflated chamber and connect velcro
straps
•Deflate chamber
•Add mat
•Ready to go!

INFLATING
At first, follow these instructions to inflate and deflate the
chamber without any person inside the chamber.
WARNING
Never take a treatment alone.
Always have someone outside the chamber to assist you.

SET UP
First connect the compressors to the back of the chamber. You will notice
that at the end of each compressor hose is a quick connect.
Simply click it onto the white fill valve.

SET UP
Check to make sure the red relief valve is shut by lining up the dots.

SET UP
There are two zippers that circle the entire end of the
chamber. These zippers are dual-triggered and can be
opened and closed from inside or outside the chamber.

SET UP
It is important that the inside zipper
is totally closed into the dock.
Dock

SET UP
Be sure that the zipper pull is tucked under the red arrow
and pulled closed all the way

SET UP
Pictured is the right and wrong way to close the inside zipper.

SET UP
•You will now need to close both zippers to inflate the chamber.
•Once the zippers are completely closed, plug the compressors
into the electrical wall outlet.
•Make sure the red knob is completely closed.
•The chamber will inflate.
•After the chamber is to pressure you can unplug the
compressors so that you can build the frame.

BUILDING THE FRAME
Notice the labeled parts of the frame on the left and how they connect to
the completed frame.
DC
B
AA
AA
B
BB
C
C
D
DD
E
E
E
C
C

BUILDING THE FRAME
Make the rectangle on the floor
D
C
B
AA
BE
D
C
B
AA
B
E
A A
E
E

BUILDING THE FRAME
When the chamber is to shape add the velcro wedges to the
bottom to stabilize the chamber.

BUILDING THE FRAME
You should have a large rectangle surrounding the chamber on the floor.

BUILDING THE FRAME
Add Part C short poles to each corner of the frame

BUILDING THE FRAME
Take both sets of Part B and screw the together to make the arches

BUILDING THE FRAME
Add the arches to each end of the frame.
You will notice there are 4 small holes on each arch piece.
The holes need to be facing to the center of the chamber.

BUILDING THE FRAME
Wrap the velcro straps around the frame arches