Sunday Living PTC-1500R User manual

FAN HEATER USER MANUAL
MODEL: PTC-1500R
Thank you for purchasing your new heater.
These operating instructions will help you use it properly and safely.
We recommend that you spend some time reading this instruction manual in order that you fully
understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction manual for future
reference
Facebook: #SundayLiving
Message: #SundayLiving
Email: [e-mail]

Email: [e-mail]
Facebook: #SundayLiving
Safety Control
1. CAUTION: In order to avoid overheating, do not cover the heater；
2. Do not use this heater with a programmer, timer, separate remote-control system or any other
device that switches the heater on automatically, since a fire risk exists if the heater is covered or
positioned incorrectly；
3. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
4. When in use never cover the heater in any way or place it close to combustible materials. The
heater will get hot, never touch it whilst in use；
5. The heater must not be located immediately below a socket-outlet；
6. Do not use the heater in areas where flammable liquids are stored or where flammable fumes may
be present.
7. Do not plug other devices in the same socket-outlet in use.
8. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard；
9. Always keep children and pets at a safe distance and never leave unsupervised in a room with a
heater that is working；
10. Do not put the device at places where it’s easy to be knocked down.
11. Always unplug or disconnect the appliance from the mains power supply when not in use. Do not
leave the heater for too long when it is in use；
12. To prevent potential prevent electrical shock, please do not touch the device with wet hands.
13. Some chemicals contained within electrical/electronic products or batteries can be harmful to
health and the environment. Only dispose of electrical/electronic/battery items in separate
collection schemes, which cater for the recovery and recycling of materials contained within.
14. This appliance cannot be used by little children and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have not been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
Product Introduction
Specifications
NOTE: The metal case is coated by plastic to be anti-corrosive and high temperature resistant.
Parts Identification
Model
Voltage
Rated Power
Rate Frequency
PTC-1500R
120V
1500W
60Hz

Email: [e-mail]
Facebook: #SundayLiving
1—Selector Switch
2—Thermostat
3—Power supply case
4—Knurled nut
5—Holder
6—Indicator light 4—Knurled nut 5—Holder 6 —Indicator light
7—Air grille
8—Plastic pad
User Guide
Put the heater upright and make sure it stays away from flammable and explosive materials.
Turn the thermostat clockwise to the maximum position. Once the desired room temperature is
reached, turn the thermostat anticlockwise until the heater switches off. The heater will switch on
and off automatically to maintain the desired temperature.
Turn the selector switch to select the desired power.
Please turn off the heater before unplugging it.
Troubleshooting Guide
Please try the following steps to solve the problem before reaching out to customer service.
Problem
Possible Cause
Solution

Email: [e-mail]
Facebook: #SundayLiving
Maintenance and cleaning
1. Switch off and unplug from the power supply before cleaning. CAUTION: Allow the product to
completely cool before handling or cleaning it. Using a moist sponge (below 50°C) to carefully clean
the exterior surface of the product periodically. Do not allow water to run into the interior of the
product, as this could create a fire and/or electrical hazard. CAUTION: Do not use petroleum,
toluene, etc.to clean the heater as they may damage the surface finish of the plastic components.
2. After cleaning, put the fan heater into a dry plastic bag for storage.
3. Set the heater switches to OFF and leave the heater to cool down fully. The product can be stored a
plastic bag when not in use. We recommend using the original (or appropriately sized) box. It is
important to keep it in a safe, dry location.
Heater does not operate
Loose socket-outlet and therefore
bad connection
Unplug and make sure
connection between plug
and socket is not loose.
No power to socket
Make sure power is applied
Blow only cool wind, no
heating
The switch is in the wrong position
Turn the switch into heating
mode
Thermostat has turned off
because the desired temperature
is reached
Turn the thermostat
clockwise (above room
temperature). If the indicator
light turns on, the heater will
switch on automatically
when it cools down.
Generate pitched whine
when in use
Foot pads are laid unevenly
Put the heater on flat surface