Sungrow SH5K-30 User manual

GD_202005_SH5K-30_Quick Commissioning Guide_V1.0 Page 1 of 5
© Sungrow Australia Group Pty. Ltd. All rights reserved.
The information in this document is subject to change without notice.
SH5K-30 Quick Commissioning Guide
Disclaimer
The material in this document has been prepared by Sungrow Australia Group Pty. Ltd. ABN 76
168 258 679 and is intended as a guideline to assist solar installers for troubleshooting. It is not a
statement or advice on any of the Electrical or Solar Industry standards or guidelines. Please
observe all OH&S regulations when working on Sungrow equipment.
The commissioning phase of the SH5K-30 inverter is straight forward and simple. All
settings are done from the front panel, and there is no longer any need to manually
enter the battery details –the system will automatically detect a powered-up battery.
On first initialisation, the flowing will appear on the LCD screen.
Enter to set/check the country code
Enter “AU” for AS/NZS 4777 as default
Select appropriate DNSP, or manually enter
grid protection parameters (Default DNSP power factor settings will be loaded)

GD_202005_SH5K-30_Quick Commissioning Guide_V1.0 Page 2 of 5
© Sungrow Australia Group Pty. Ltd. All rights reserved.
The information in this document is subject to change without notice.
Enter to save
Select if there is an existing inverter on the
same phase
Must be enabled if there is another inverter
Enter inverter AC power. Export can also be set

GD_202005_SH5K-30_Quick Commissioning Guide_V1.0 Page 3 of 5
© Sungrow Australia Group Pty. Ltd. All rights reserved.
The information in this document is subject to change without notice.
Press ‘Enter’ to save
Set export if required
Check / set time and date as required
Incorrect time setting will affect monitoring
Save

GD_202005_SH5K-30_Quick Commissioning Guide_V1.0 Page 4 of 5
© Sungrow Australia Group Pty. Ltd. All rights reserved.
The information in this document is subject to change without notice.
The backup is disabled by default
Enable if desired
Enter the amount of capacity to be reserved
for blackout
Save
Select Exit

GD_202005_SH5K-30_Quick Commissioning Guide_V1.0 Page 5 of 5
© Sungrow Australia Group Pty. Ltd. All rights reserved.
The information in this document is subject to change without notice.
Press Enter
Inverter will go into ‘Standby’ momentarily.
Confirmation that Energy Meter and Battery are connected
If the issue persists after following above procedures, please take photos testing on
site and contact Sungrow Service Department on 1800 786 476 or email to
[email protected].