Manufactured by Sunlight Supply®, Inc. under license from Hygro International Pty Ltd
www.sunlightsupply.com www.adjustawings.com www.super-spreader.com
Vancouver, WA • Eureka, CA • Livermore, CA
Ontario, CA • Denver, CO • York, PA
Nashville, TN • Pompano Beach, FL
Step 5 Step 7
Step 8
Select one adjustment wire. Take the end with
the single stopper and thread it through the first
keyhole, then thread it back through one of the
other keyholes (as shown below).
This presets the reflector width
Step 6
IMPORTANT !!! While holding the opposite end of
the adjustment wire (that has 2 stoppers). Carefully
bend the wings back away from their spine and
lock the end stopper into the single keyhole pro-
vided. Repeat steps 5 and 6 at the opposite end
of the wings to attach the 2nd attachment wire.
Adjust-A-Wings settings are changed by reversing
STEP 6 & choosing a different position from STEP 5.
NOTE: Adjust one end of the wires at a time.
WARNING: For safe operation, ensure that the
power is off before adjusting the wings or socket.
Take the socket and using the 2 thumb screws
provided (attach as shown below).
IMPORTANT!!! The 2nd stopper on each adjustment
wire is for grip only in these procedures.
Your Adjust-A-Wings now look like this.
