Place inner waterproof floor liner
into the floor of the Sun Hut. Insert
plastic ties into the holes at the
corners of the floor liner and
secure to the corner poles (see
Figure A). This will make the Sun
Hut floor water-tight.
STEP 8
Figure A
Place canvas flat with bottom open on the floor. Unzip
canvas completely. Face front of Sun Hut with fan
& blower brackets in upper right. Place frame into bottom
of canvas and pull canvas up around all four corners so
that it fits tightly around bottom of frame (see diagram).
STEP 6
Slide flange into canvas and ring above fan & mounting
rods. Push bolt through flange, canvas & ring; and tight-
en wing nuts on the outside. Attach intake flange on
bottom left. Slide blower and filter straps onto brackets.
Tighten straps around blower and filter. Use duct work
(not included) to connect blower to flange.
OPTIONAL FLANGES
Optional flanges and optional two-way flanges are also
available. For any questions or to see optional items
for your Sun Hut, talk to your local dealer. Log on to
www.n-g-w.com to locate a dealer near you.
www.nationalgardenwholesale.com
WEST: 888.478.6544 • EAST: 888.265.9005
STEP 7 Pull canvas up the
back and over the
top of the frame.
Carefully pull
canvas around the
4 corners of the
ceiling. Fits snug.
Pull sides toward
the front.
(see diagram).
STEP 9
STEP 10
Zip up doors to make
sure that your Sun Hut
fits properly.
FILTER
STRAPS
BLOWER
STRAPS
