Sunlighten Signature Power Box User manual

Signature®Power Box Installation Guide
We’re very excited you received your replacement power box and are eager to get your unit
back up to optimal operation! This power box is designed with customer installation in mind,
and this guide will help you through that process while avoiding any potential pitfalls.
Labeling
The wiring connections of your power box are labeled with stickers to help you classify them.
INSTALLATION
Step 1
Unplug the unit from the power source, or ip the breaker for the dedicated circuit to the
sauna.
Step 2
Your dust covers, the pieces of plywood board screwed down on the roof of the unit, cover
the power box. Elevate yourself with a stepladder or something similar so that you’re looking
down into the roof of the sauna and unscrew the dust covers. Remove them, and you’ll see
the roof divided into three segments, with your power box in the center.
Step 3
Once exposed, remove the phillips screws anchoring the power box to the ground. Two on
the long front edge, and one on the right edge close to the back wall (as you are facing the
back wall).
Step 4
Disconnect the power cord on the left edge of the power box.

Step 5
We are now ready to begin disconnecting the power box or boxes from the wiring from the walls.
Move clockwise around the perimeter of the power box(es), starting with the G1 connector for
the left wall from S2, and moving on to G14 from S3, G4 from S4, and fi nally G3 from S5.
Step 6
Looking at the power box from the front, disconnect the power transformer on both its right side
(G39) and left side. One side of the transformer will plug into the connector marked with G5, and
the other into G8.
Step 7
Remove the small black box near where the power box sits, the intermediary wire, connecting S6
(a split wire out to both lights) and the power box.
Step 8
The Signature power box being replaced is now ready for extraction. Remove it from the central
segment and insert your new replacement boxes.
Step 9
Congratulations! All connections will now be separated for removal of the power box. To install
your replacement power box, you can reverse the same steps making the connections described
above. Find the corresponding connections for each side of your new power box, plugged into
the receptacles found around the roof perimeter. Please see the diagram on the next page for
which connections to pair as a reference.
If you have any questions, you can contact us in the following ways:
Phone: [phone]
Live Chat on our website or view FAQs: www.sunlighten.com/customer-service
DM on social: facebook.com/SunlightenSaunas or instagram.com/sunlightensaunas/
Signature Power Box Installation Guide G1 Left Wall
plugs into S2
G14 Back Wall
plugs into S3
G4 Right Wall
plugs into S4
G3 Front Wall
plugs into S5
G9
G5
1 2 3 4
1
21 2
3
Connect
Connect
1 2
G5
1. AC power (L line)
output to Interior
light transformer
2. Vacancy
3. AC power (N line)
output to Interior
light transformer
G6
1. AC power
(L line) output
to switch power.
2. AC power (N line)
output to switch
power
G8
1. DC 12V
input from
switch power
2. GND
G7
1. DC 12V output
to Exterior light
2. GND
3. DC 12V output
to CD player
4. GND
G6
G7
G8