SUNON YD9001 User manual

Please read this manual carefully before any operation
and keep it properly for future use.
Assembly Manual
YD9001
Four-layer Open Bookcase

YD9001 Assembly Manual
Keep all parts out of the children’s reach.
WARNING Panels
Panel List
01 02
Panels NumbersSize
5
Top Board（×1）
915*295*25mm
4
3
Side Boards（×2）
1180*294*25mm
66
Back Boards（×2）
1184*435*5mm
7 7 7
Movable Shelf Panels（×3）
862*272*18mm
1
Bottom Board（×1）
863*273*18mm
2
Base Panel（×1）
70*863*18mm
You need to have a crosshead screwdriver beforehand.
Place all the panels on a clean and smooth surface, such as a rug or
carpet, to prevent them from being scratched.
Don’t tighten screws or bolts until all the pieces are fitted.
It is recommended to have 2 persons to complete the assembly.
If you have any issue regarding the product, please contact us at
[email protected].
Make sure that all parts in your product package, including panels and
accessories, match up with those listed in the Panels & Accessories list.
NOTE
CONTACT US
crosshead screwdriver Not included in package.
NOTE
In case of any doubts,contact Sunon.
3
Handle with care,protective layer is required.
2
Safe carriage,multi-people are needed.
1

YD9001 Assembly Manual
Assembly Instructions
Accessories List
Three-in-one Connector
15*32mm
A
（×9+1）
Three-in-one Connector
15*32mm
A
（×1）
Three-in-one Connector
15*32mm
A
（×4）
Roundhead Self-tapping
Screw
M3*16mm
D
（×6+1）
Back Board Slot
/
G
（×1）
Adjusting Pin
M8*21mm
E
（×4）
Movable Shelf Support
5*15mm
F
（×12）
Cover for Three-in-one
Connector
17.8*4.5mm
B
（×9）
Wood Pin
8*40mm
C
（×10）
Wood Pin
8*40mm
C
（×6）
Step 1：
Fit and fasten the Base Panel on the Bottom Board.
Step 2：
Fit and fasten the Bottom Board on each of the Side Panels.
03 04
1
2
A
C
4
3
1
2

YD9001 Assembly Manual
Roundhead Self-tapping
Screw
M3*16mm
D
（×6）
Back Board Slot
H1479
G
（×1）
GA Adjusting Pin
M8*21mm
E
（×4）
Three-in-one Connector
15*32mm
A
（×4）
Wood Pin
8*40mm
C
（×4）
Step 3：
Fit and fasten the Top Board on each of Side Panels.
Step 4：
Insert Back Board along with side slot,and connect them with
Back board slot.
05 06
A
G
D
E
E
E
E
C
3
6
1
6
1
4
5
G
6
6

YD9001 Assembly Manual
Movable Shelf Support
5*15mm
F
（×12）
GA Cover for Three-in-one
Connector
17.8*4.5mm
B
（×9）
Step 5：
Put the Movable Shelf Panels in wherever you want.
07 08
Step 6：
Finished as below.
F
F
7
7
7