3. Gentlypryopenonesideofeitherclipwithfingertip.
4. Liftupbulb.
Toreplacenewbulb:
• Gentlypryopenclipsandcarefullyinsertbulbinplace.
• Connecttheconnectorsonbothends.
• Replacebackcoverandthe6screws.
Water Removal
1.Using the water tank
When water tank is full, unit will automatically shut-off and the red
water full indicator will illuminate. To empty water from the tank, first
turn the unit off. While holding the top of the unit firmly with one hand,
gently pull and remove water tank with the other hand. Empty the
water and replace the water tank. If the water tank is not replaced
properly, the red LED light will stay on.
2.Continuous drainage
Remove the rubber plug from inside the water tank and connect the
water pipe (included) to the drain spout. Once water level inside the
tank rises above the drain spout, water will begin to flow out the pipe.
Water pipe is approx. 39" long with 5/16" inner diameter.
Specification
Working voltage
Rated power
Water tank capacity
Unit weight
Daily dehumidifying rate
Product size
DC 12V
68W
2.2 liters (74.4 oz.)
4.85 Ibs
0.65L/22 oz (86°F 80% RH)
14.17 x 9.05 x 5.5 in.
Danger
• Do not use this unit in a bathroom or shower.
• Do not spray water directly onto the unit or adaptor
• Do not allow water to drip onto internal parts
• Do not use petrol, benzene or any chemicals to clean the unit, which
will damage the surface.
Cleaning & Maintenance
• Turn the unit off and unplug from main socket before cleaning or
maintenance.
• Use a soft and slightly damp cloth to wipe off the surface.
• The air inlet can be cleaned with vacuum and brush attachment or
compressed air.