Sunrich Tech PCIe 3 User manual

PCIe 3 Ports USB 3.2 Host Adapter
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN3000000180 Page 2
Contents:
Chapter 1: Introduction..........................................................3
1.1 Features........................................................................3
1.2 System Requirements..................................................4
1.3 Package Contents.........................................................4
Chapter 2: Getting Started.....................................................5
2.1 Hardware Installation ..................................................5

MN3000000180 Page 3
Chapter 1: Introduction
1.1 Features
⚫PCI-Express x8
⚫One USB 3.2 Gen 2x2 20Gbps Type-C Port and Two USB 3.2
Gen 2 10Gbps Type-A Ports
⚫Compliant with Intel’s eXtensible Host Controller Interface
(xHCI) Specification Revision 1.1
⚫Support Multiple INs function
⚫Compliant with USB 3.2 Specification Revision 1.0
⚫Compliant with UASP Revision 1.0
⚫Support the following speed data rates:
1.5Mbps / 12Mbps / 480Mbps / 5Gbps / 10Gbps / 20Gbps
(Only Type-C port supports 20Gbps)
⚫Support USB Battery Charging 1.2 (only Type-A)
⚫No need to install drivers
⚫Maximum total power output of the 3 ports is 30W. As the power
provided by PCIe slot is up to 75W, there is no need to connect
the SATA power connector to PSU.

MN3000000180 Page 4
1.2 System Requirements
⚫Windows 8.x/10 (32/64 bit);
⚫Linux 3.2 later
⚫One available PCI Express x8 or x16 slots
1.3 Package Contents
⚫1 x PCIe 3 Ports USB 3.2 Host Adapter
⚫1 x User Manual
⚫1 x Low Profile Bracket

MN3000000180 Page 5
Chapter 2: Getting Started
2.1 Hardware Installation
1. Turn off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCI-Express x8、x16
slot.
4. To install the card, carefully align the card’s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5. Replace the slot bracket’s holding screw to secure the card.
6. Secure the computer cover and reconnect the power cord.