Operation
Choose mode
Press" 1 "and" 2 "key for 2 seconds, r , u digital display flashes, press "3 "key choose 1 or 2 mode .
If the board display ru1: stand-alone mode; ru2: slaver mode. press any button for 2 seconds to
confirm the mode you need.
Safety & Warnings
Warranty Agreement
1) The product shall be installed and serviced by a qualified person.
2) IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a water proof
enclosure.
3) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4) Please check if the output voltage of any LED power supplies used comply with the working voltage of the
product.
5) Never connect any cables while power is on and always assure correct connections to avoid short circuits
before switching on.
6)
7) For update information please consult your supplier.
Please ensure that the cable is secured tightly in the connector
1) We provide lifelong technical assistance with this product:
3-year warranty. We print date on every products, for example :1125 means year 2011,week 25.The
warranty is for free repair or replacement and covers manufacturing faults only.
For faults beyond the 3-year warranty we reserve the right to charge for time and parts.
2) Limited Warrenty
Any defects caused by wrong operation.
Any damages caused by unauthorized removal, maintenance, modifying, incorrect connection and
replacement of chips.
Any damages due to transportation, vibration etc. after purchase.
Any damages caused by earthquake, fire, lightning, pollution and abnormal voltage.
Any damages caused by negligence, inappropriate storing at high temperatures and humidity or near
harmful chemicals.
Product has been updated
3) Repair or replacement as provided under this warranty is the exclusive remedy to the customer.
Operation under DMX512 SLAVE mode
Under this mode ru2, it is just a standard of DMX512 decoder slave, it can connect DMX512
MASTER signal with DMX512 signal input port, to be controlled by DMX512 master.
Through buttons to set desired DMX512 address, the digital numeric display the starting address.
For example: the digital numeric display 001, it means this DMX slave include 001,002,003,004
addresses (under situation of 4 CH).
Operation under stand-alone mode
Under stand-alone mode ru1, it can be operated as a independent led controller, then can not
accept DMX input.
At stand-alone mode, it is just an individual led controller, no DMX in or out. The function as
follows:I f you choose ru1, after you press any button>2seconds to confirm, the three buttons on
board will work like below functions
1 2 3
“1" button
“2" button
“3" button Only under “ru1” stand-alone mode
Choose channel
Hold the “Mode” and”Bright”button for two seconds, cH digital display flashes,then press “Speed”
button to choose”3”or “4”,then press any button for 2 seconds to confirm 3 or 4 channels you
need.
Speed button
To speed up/down color changing,0-9 speed level cycling changing,”0”is the maximum speed,
“9”is the minimum speed. The “Speed” button is only used under dynamic effects which you can
get from “Mode” button.
Mode button
Press “Mode” button to see total 9 dynamic effects in this way: effects1-pause-effects2-pause-
effects3-pause...
Bright button
To adjust the brightness,1-8 level brightness, cycling,”1”is the lowest brightness,”8”is the highest
brightness.
