superbrightleds PLDT-W2BK User manual

LED Low Voltage Landscape Light
Important: Read all instructions prior to installation. PLDT-W2BK
Parts Included
1. Install the lamp head (A) to the threaded center tube (B).
2. Install the ground stake (C) to the threaded center tube (B).
3. Toinstall,loosenthegroundwithatrowel/shovel(notincluded)and/orsoftenthesoilwithwater,thenpressthextureintothe 
 ground.Donotuseahammer.Donotexertexcessiveforceonthexturewhileinstallingasthismaycausethexturetobreak.
4. Remove the quick connector cap (D) from the quick connector base (F). Set the connector block (E) aside.
Beforebeginningassembly,installationoroperationofproduct,makesureall
parts are present. Compare parts with package contents list and diagram on
previouspage.Ifanypartismissingordamaged,donotattempttoassemble,
install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 15 minutes. Helpful tools: Trowel/Shovel.
Preparation Instructions
Assembly Instructions
Instruction Sheet
Part Number:
A - Lamp Head
B - Center Tube
C - Ground Stake
(D,E,F) - Threaded Connector
AA-AdapterTrays
4400 Earth City Expy, St. Louis MO 63045 866-590-3533 [email protected]
12
5. Four(4)adaptertrays(AA)areincluded.Eachismarkedaccordingly:12AWG,14AWG,16AWGand18AWG.Selecttheadapter
 tray(AA)thatmatchesthegaugeofthepowercable(notincluded).
6. Placethepowercableontheadaptertray(AA).Alignwiththegroovesinthequickconnectorbase(F)followedbytheconnector 
 block(E).NOTE:Toensureuniformbrightness,therstxtureshouldbeaminimumof10ft.(3m)fromthepowerpack/transformer
(not included).
7. Install the quick connector cap (D) onto the quick connector base (F). Screw the quick connector cap (D) until it is secure, making
sure not to over-tighten.

4400 Earth City Expy, St. Louis MO 63045 866-590-3533 [email protected]
Care and Maintenance: To clean, unplug lamp and wipe with a damp, non-abrasive cloth.
Troubleshooting
Warranty
Warning
PROBLEM
LED light will not turn on
LEDlightickers
POSSIBLECAUSE
1. No power.
2. Loose wire to the connector
3. Connector not making contact with
 primarycable.
4. Powerpack/transformer’sphoto
 cellsensorisexposedtounwanted
light source.
1. Wattageofpowerpack/transformer
 maybeexceeded.
CORRECTION ACTION
1. Wattageofpowerpack/transformermaybe
 exceeded.
2. Makesurebrasscontactpinspiercetheplastic
wire insulation and are touching the copper
wires inside.
3. Makesurecoveristight.Ifproblempersists,
 repeatsteps3to6ontheinstructions.
4. Makesurethatpowerpack/transformer’sphoto
 cellsensorisnotexposedtolights.
1. Checkmanufacturer’sspecicationfor 
 maximumwattage.
Themanufacturerwarrantsallofitsproductsagainstdefectsinmaterialsandworkmanshipforthree(3)yearsfromthedateofpurchase.
Ifwithinthisperiodtheproductisfoundtobedefectiveinmaterialorworkmanship,pleasecontactthemanufacturer,acopyofthe
original sales receipt will be required as proof of purchase. The manufacturer will, at its option, repair or replace the product. This
warrantydoesnotcoverproductsbecomingdefectiveduetomisuse,accidentaldamage,improperhandlingand/orinstallationand
specicallyexcludesliabilityfordirect,incidentalorconsequentialdamages.Assomestatesdonotallowexclusionsorlimitationsonan
impliedwarranty,theaboveexclusionsandlimitationsmaynotapplytoyou.Thiswarrantygivesyouspeciclegalrights,andyoumay
haveotherrightsthatvaryfromstatetostate.
• Riskofreorelectricalshock.Readallofthese
instructionsthoroughlybeforeuse.Keepthisinstruction
manual in a safe place for future reference.
• Do not install or connect wires with wet bands.
• Donotinstallthisproductwithin10ft.fromapool,spa,
fountain,orotherbodyofwater.
• Thexturewireandprimarycablesareintendedfor
shallowburial-maximumdepthmustnotexceed3in.
• Forlow-voltagelandscapelightingsystemsonly.
• Do not step on or drive over the branch cable or power
cable.
Caution
• Thislightingxtureisonlysuitablefora12~15volt
powersupply.
• ThisLEDlampisahighlyefcient,extremelylow
wattage,energy-savingproduct.However,itisnot
recommended to use a power pack/transformer over
100watts.
• Useshieldedcableforoutdooruseinthefollowing
sizes:18G,16G,14G,12G.
• Do not submerge in water.
• Donotrepairormodifythisproduct.