LED Panel Light with Mounting Kit
Important: Read all instructions prior to installation.
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V0.1 02/27/2019
Included Parts
Mounting Hardware
Installation
Dimming Instructions
User Manual
LP-NW3030-35-12V
LP-NW6030-40-12V
1 - Even Glow Panel (LP-NW3030-35-12V, LP-NW6030-35-12V)
4 - Mounting Brackets
4 - Anchors
*Note: LP-SMK-BKT Included
with panel
1. Use a Phillips screwdriver to remove screws from LED Panel.
(Fig. 1) Use these screws to attach 4 Mounting backets to
the panel. Note: Make sure to orient the Mounting Brackets
correctly (varies by application).
2. Hold Panel against surface where it is to be mounted.Mark
surface with pencil for proper placement of the Panel.
3. While anchors are provided for use in mounting, they are not
appropriate for all applications.
Pulse Width Modulation Controls
0%(OFF) - 50%(half dimming) - 100%(full brightness)
The PWM frquency range is 1–10KHz.
Do not exceed 8 VDC on the PWM DIM wire.
Analogue Dimming Controls
As analogue voltage increases, the brightness increases.
0VDC = OFF, 0.25 VDC = minimum brightness, 1.3 VDC = maximum brightness
Do not exceed 8VDC on the Analogue DIM wire.
FIG 1
Mounting Screws
DIM -
DIM -PWM Dimming
H
L
H: 2~8VDC
L: )~0.5VDC
Remote Switch
On / Off (Optional)
Analog DIM -
PWM DIM -
DIM -
DIM -
Remote Switch
On / Off (Optional)
Analog DIM -
0.25V~1.3V 8V Max
PWM DIM -
