Sur-Pro WIT110 User manual

SurPro Wire Tying Machine (WIT110) User Manual
Step 1 Set up wire and clip as illustrated below. Ensure wire is fully inserted.
LOCATE A DEALER NEAR YOU 18884438889 WWW.SURPRO.COM
APosition wire
against the slot. BVerify clip has contact against
the spindle rod.
CInsert wire between
pegs in the spindle
block.
Scan to Watch the
Instructional Video:

Step 3 Turn handle clockwise to release the
switch. Wait for the cradle to stop spinning to
properly replace handle into the cradle. Once
motor cradle has stopped spinning, use the
plastic flywheel to rotate the cradle to the
proper receiving position.
Step 2 Lift handle and turn counterclockwise
until switch is firmly depressed. Motor will
activate when the switch is depressed, and the
tie will be made.
LOCATE A DEALER NEAR YOU 18884438889 WWW.SURPRO.COM
The handle must be
firmly depressed against
the switch to activate.
WARNING
• Only use the ywheel once the motor
has come to a complete stop.
• Do not use the ywheel to purposely
stop the spinning motion. This action
may lead to injury!
Watch the Instructional Video Here: https://youtu.be/Tbf_-nqNZ6E