Suunto EON STEEL 1.2 User manual

1. GET STARTED 2. CUSTOMIZE
1.
4. SET DIVE GAS(ES)3. SET DIVE SETTINGS
3. After customizing your device, disconnect
the USB cable.
2. Download and install DM5 software.
1. Connect your device. 1. Keep middle button pressed to access menu.
3. Select the gas according to your dive plan.
Select Edit if your mix is not in the list.
1. Keep middle button pressed to access menu.
3. When settings are ready, keep middle button
pressed to go back and exit.
2. Scroll with upper or lower button to Dive
settings and select with middle button.
5. PAIR SUUNTO TANK POD
General
2. Scroll with upper or lower button to
Gas and select with middle button.
1. Wake up the device by connecting the
USB cable.
2. Follow the start up wizard to set up
the device. When ready, the device
goes to Surface mode.
PARTS
(1) Suunto EON Steel
(2) Protective boot
(3) USB cable
(4) Bungee adapter
(1)
(4)
(2)
(3)
3. Fully charge before first dive.
19:36
depth, m
divetime
0
0’
Air
www.movescount.com/dm5
synchronizing
DO NOT DISCONNECT
NOTE:
Do not disconnect cable while syncing.
1. Install Tank POD and open tank valve.
2. Wait for green LED on Tank POD to flash.
5. Select the gas for the Tank POD.
19:36
depth, m
divetime
0
0’
Air
19:36
depth, m
divetime
0
0’
Air 2s
Dive settings
19:36
depth, m
divetime
0
0’
Air 2s
General Gases
Air Air
19:36
depth, m
divetime
0
0’
Air 2s
NOTE:
Buttons are locked while cable is connected. WARNING:
The battery level indication
shown when pairing the Tank
POD is an approximation only.
The POD battery may deplete
faster than the indication
suggests.
3. If your EON Steel has a blank screen, press
any button to activate it.
4. Hold your device close to the Tank POD
as shown.
NOTE:
In CCR mode, you can
set both OC and CC
gases.

CHANGE VIEWS MENU
depth, m
dive time
18.2
12’
19:36
depth, m
dive time
0
0’
Air
75’
no dec o
depth, m
8.2
dive time
12’
Air
depth, m
18.2
48°
depth, m
8.2
dive time
12’
Air
depth, m
dive time
0
0
48°
depth, m
0
dive time
0’
Air
en
SUUNTO EON STEEL 1.2
QUICK GUIDE
WARNING: Download and read
complete User Guide before diving
www.suunto.com/support
©Suunto Oy 6 /2014, 3/2015, 10/2015. All rights reserved.
Suunto is a registered trademark of Suunto Oy.
SUUNTO CUSTOMER SUPPORT
1. www.suunto.com/support
www.suunto.com/mysuunto
2. AUSTRALIA [phone]
AUSTRIA [phone]
CANADA [phone]
FINLAND [phone]
FRANCE [phone]
GERMANY [phone]
ITALY [phone]
JAPAN [phone]
NETHERLANDS [phone]
NEW ZEALAND [phone]
RUSSIA [phone]
SPAIN [phone]
SWEDEN [phone]
SWITZERLAND [phone]
UK [phone]
USA [phone]
LOW BATTERY ALERT
<3h
= dive hours remaining
NOTE:
Thoroughly rinse and dry your device after diving, especially after salt-water dives.
CE
Suunto Oy hereby declares that this dive computer is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation. This product has been tested to comply with FCC standards and is intended
for home
or office use.
Changes or modifications not expressly approved by Suunto could void your authority to operate
this device under FCC regulations.
IC
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil est conforme aux normes RSS hors licence d’Industrie Canada. Son utilisation est
soumise aux deux conditions suivantes :
(1) cet appareil ne doit pas causer d’interférences,
(2) cet appareil doit accepter toute interférence, y compris les interférences pouvant entraîner un
fonctionnement non désiré de l’appareil.
CHINA [phone]
Dive planner
Dive settings
General About EON
Compass
Clear bearing
Calibrate
Declination
Gauge
Air/Nitrox
Trimix
CCR Personal
Altitude
Gas max. pO2
High setpoint
Switch low
Low setpoint
Switch high
Setpoints
CC gases [gas mix]
Units & formats
Brightness
Time & date
Flip display
Device settings
Gas(es) OC gases [gas mix]
Mode
Parameters
Alarms
Logs [log date]
Set consumption
View planner
Set tank size
Set tank pressure
Deepstop
Safety stop
Last stop depth
Tones