Svan SVVN041C User manual

Compress Refrigerator
Operating Instruction
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING
INSTRUCTION.
MODEL: SVVN041C

IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock, or injury
when using your refrigerator, follow these basic
precautions:
Read all instructions before using the APPLIANCE.
•If the supply cord is damaged,it must be replaced by the manufacturer,its service agent or
similarly qualified persons in order to avoid a hazard.
•This appliance is not intended for use by persons(including children) with reduced
physical,sensory or mental capabilities,or lack of experience and knowledge,unless they have
been given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
•WARNING：To avoid a hazard due to instability of the appliance，it must be fixed in accordance
with the instruction.
•WARNING: When positioning the appliance,ensure the supply cord is not trapped or damaged.
•WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear
of the appliance. -Save these instructions-
INSTALLATION INSTRUCTIONS
•This appliance is designed to be free standing only, and should not be recessed or built-in.
•Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To level your unit，
adjust the leveling legs at the bottom of the unit.
•This appliance is not designed to be installed inside of a cabinet where the front is covered by any type of
door.
•Allow10 cm of space between the top,the back and sides of the wine unit, which allows the proper air
circulation to cool the compressor and condenser.
•Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
•Avoid locating the unit in moist areas.
•Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut
or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an authorized Products service center.
•After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3 hours before placing
any items in the compartment.
Remark：Please remember to keep some water in the cabinet to keep the humidity
For disposal of the appliance:
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. And the disposal should only be done
through public collection points.
For installation, servicing:
appliance should placed on a horizontal floor and keep the ventilation freely. don't try to replace or repair any
components by yourself, ask the service agency for help if necessary.
For handling:
Always handle the appliance to avoid any damage.

OPERATING OF YOUR WINE COOLER
It is recommended you install the Wine Cooler in a place where the ambient temperature is
between 23℃-26℃.If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected. For example, placing your unit in extreme cold or hot
conditions may cause interior temperatures to fluctuate. The range may not be reached.
Temperature Ranges For Your Wine Cooler
Upper zone Temperature Range
5-13℃
Bottom zone Temperature Range
13-18℃
Control Panel
Temperature control
⚫You can turn the interior light ON or OFF by pushing the button once.
⚫The light will be turned off automatically if it remains ON for 10 minutes. You have to push the
button again and the light will turn back on.
⚫You can select temperature display setting from Celsius to Fahrenheit degree by pushing the
button for 2 seconds.
⚫Your Wine Cooler has been equipped with an "automatic” control panel lock, that will activate 20
seconds after the last time a button has been touched.
⚫Push the button for 2 seconds to unlock the control paneI. You will hear a "BEEP" sound
to alert you that the control is now active.
Push the button once, you can set the upper zone temperature;
Push the button twice, you can set the bottom zone temperature.
⚫You can set the temperature as you desire by pushing the or button on the control
panel. The temperature that you desire to set will increase 1℃ if you push the button
once, on the contrary the temperature will decrease 1℃ if you push the button once.
Note
When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the Wine Cooler is running for a few hours everything will be back to normal. Your wine

cooler has been equipped with an“automatic”control panel lock， that will activate 20 seconds after
the last time a button has been touched。
Energy Saving Tips
•The unit should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.
•Let hot foods cool to room temperature before placing in the unit. Overloading the unit
forces the compressor to longer.
•Be sure to wrap foods properly，and wipe containers dry before placing them in the unit.
This cuts down on frost build-up inside the unit.
•Unit storage bin should not be lined with aluminum foil，wax paper，or paper toweling.
Liners interfere with cold air circulation，making the unit less efficient.
•Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time，and close the door as soon as possible.
PARTS & FEATURES
1
2
3
5
4
8
7
6
1Wooden Shelf 5 Leveling Leg
2Upper Zone 6 Top Hinge
3Zone Separator 7 Stainless Steel Door Frame
4Lower Zone 8 Stainless Steel Handle

PROBLEMS WITH YOUR APPLIANCE?
You can solve many common refrigerator problems easily, saving you the cost of a possible service call. Try
the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Unit does not operate.
Not plugged in.
The circuit breaker tripped or a blown fuse.
Turns on and off frquently.
The room temperature is hotter than normal.
A large amount of food has been added to the
unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Vibrations.
Check to assure that the unit is level.
The unit seems to make too much noise.
The rattling noise may come from the flow of the
refrigerant，which is normal.
As each cycle ends，you may hear gurgling
sounds caused by the flow of refrigerant in your
unit.
Contraction and expansion of the inside walls
may cause popping and cracking noise.
The unit is not level.
The door will not close properly.
The unit is not level.
The door was reversed and not properly installed.
The gasket is dirty or bent.
The shelves, bins, or baskets are out of position.
Correct disposal of this product
This symbol on the product, or in its packaging, indicates that this product
may not be treated as household waste. Instead, it should be taken to the
appropriate waste collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by the inappropriate
waste handling of this product. For more detailed information about the
recycling of this product, please contact your local council, your household
waste disposal service, or the shop where you purchased the product.