swiftech MCR80-F User manual
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595
-
8009 F. (562) 595
-
8769
Page
1
of 2
Packing list
MCR80 radiator
1
80mm fan guard
1
#6 X 7/8” Philips screw type B
8
80x80x15mm fan
2
Nylon washers
4
Double snap grip hose clamp size C
2
*
Note of caution regarding the
inlet/outlet side of the radiator:
The fan guard and nylon washers MUST BE INSTALLED when using the provided self
-
tapping screws. They are necessary to allow sufficient clearance between the tip of the
screws and the radiator core. Failure to use them will systematically result in permanent
damage to the radiator, as the screws will otherwise punch a hole in the core channels.
Users are advised that such damage is not covered under our warranty.
Likewise, if fans other than the provide 80x80x15mm fans a
re installed, users should
carefully check the clearance remaining between the retention screws and the radiator
core.
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595
-
8009 F. (562) 595
-
8769
Page
2
of 2
Installing the tubing:
It is usually easier to install the tubes before the
radiator is fastened to the case. Cut sufficient
length
of tubing to connect to the rest of the
circuit and tighten the clamps to the radiator
inlet and outlet. There should be only 3 to 4
notches left “open” once the clamp is fully
tightened.
Electrical connection:
Once
the radiator is installed inside the case, the final step is to connect the molex connector to your
computer power supply.
Radiator specifications:
Fans specifications:
Height: 4.1” (104.8mm); Width: 3.25” (82.5mm); Depth:
3.2” (81.6mm)
2-
pass 80 mm rad
iator specifically developed for PC
CPU and VGA liquid cooling
Double
-
row high internal volume design
Rated for 236.6 KCal per hour (938.89 BTU per hour) or
275W
80 mm (3 inch) Copper core consisting of flat tubes for
maximum heat conductivity
High
-
dens
ity copper fin configuration for enhanced heat
dissipation
3/8" OD inlet and outlet for use with 3/8" ID tubing.
Each fan:
Part #
Voltage
(V)
Current
(mA)
Revolution
(RPM)
Volume
(CFM)
Max
Static
pressure
(InH20)
Sound
Noise
(dBA)
G8015
-
L
12
120
3200
29
0.11
32
Table of contents
Other swiftech Heater manuals
