Swimmingly WiFi User manual
!
!
Swimmingly™ WiFi: Assembly Instructions
Name of SSID: Swimmingly 5
AND / OR Swimmingly 2.4
Password for both: swimmingly (case sensitive)
We recommend the 5ghz SSID as primary and
2.4ghz as secondary
Swimmingly™wifi is preconfigured for “Plug & Play.” No internet connection required. Click the training link
at https://clubhouse.swimmingly.app for your Swimmingly® Help Guide and complete tutorials.
Open the Starter Kit box. Locate the following contents:
1. EnGenius wifi Access Point w/ sea lion sticker on front.
2. Hanging strap attached to back of wifi access point.
3. Ethernet Cord (one end already connected to access point).
4. 4 white Antennas (to attach to wifi access point).
5. Access Point black PoE Injector (sea lion sticker on it).
6. AC power cord.
Step 1: Attach four (4) antennas onto the wifi access point. Make sure the 2.4 GHz. antennas connect to the 2.4 GHz.
sockets, and the 5 GHz. antennas connect to the 5 GHz. sockets. Both the antennas and sockets are labeled
accordingly.
Step 2: Plug the unattached end of the ethernet cord into the PoE (power over ethernet) port of the black PoE Injector
(sea lion sticker located over the port). Note: on the black PoE injector, the LAN port should be left unused.
Step 3: Ensure that the ethernet cord is running from the wifi access point to the PoE port on the black PoE injector.
Step 4: Hang the wifi access point 7-9 feet off the ground using the strap. We recommend hanging the wifi access point
on the backstroke flags by the starter’s podium (by the perimeter of the pool).
Step 5: After optimizing the location of the wifi access point (backstroke flag pole next to starter), then find the nearest
reliable power supply. If you need an extension cord, make sure it works reliably (test is before your swim meet).
Test your wall outlets as well before your season. Don’t leave the black poe injector exposed to the elements
(sun, water etc). If a reliable wall outlet is not reachable, you can power the wifi access point right at the starter’s
podium with a portable power station (battery). This avoids having to use extension cords or use an unreliable
wall outlet. Contact Swimmingly for our recommendation for portable power station.
Step 6: Confirm your wifi access point is receiving power by confirming the power light and the 2.4 & 5ghz lights are on.
Next, using your wireless device, open your network settings to confirm that both Swimmingly networks are
present and you can join them:
012 Swimmingly 2.4 The 3 digits before ‘Swimmingly’ are unique to your unit
012 Swimmingly 5
Step 7: Download your Swimmingly® Help Guide to follow the next steps to run your first swim meet. See the back of
these instructions for a diagram of your wifi setup.
!
Sea lion sticker
on access point
“AP” and PoE
injector
!
!
!
!
Swimmingly.app team@swimmingly.app
(866) 377-SWIM (7946) Fun swim meets, made simple
Download your Swimmingly® Help Guide & tutorial walkthroughs by clicking on the
training link here:
https://clubhouse.swimmingly.app
Team Hotline:
866-377-SWIM (7946)
Email Support:
Table of contents
