Swiss Made Solar-Fizz V-15 User guide

Assembly and
Instruction Manual
Page 1
swissmade
Congratulations to your decision to buy a Solar-Fizz.
The Solar-Fizz is a Swiss Quality Product and it has been
manufactured with great Care and high class workmanship.
Should you experience any technical Problems, please contact
your Seller or contact us directly trough:
www.solar-fizz.ch
We hope you will enjoy your new Solar-Fizz.
Page 2
Introduction
Ple
ase read the
Solar-Fizz
Owners Manual troughout
before assembling and connecting the Solar-Fizz.
Make sure not to ignore any advise written in this
Manual in order to keep your Solar-Fizz in good
working Condition.
solar

Page 3
Maintenance
Your notes:
1
–
2 –
3–
4 –
5 –
6 –
During the freezing Period, please empty the Solar-Fizz
completly and store it in a dry place.The valves of the
mixing battery should be left open. We advise you to store
the Solar-Fizz in the transport Box.
The solarcollector must not
be cleaned with any chemical
detergents. Please use regular water only.
The shower top can be cleaned with any regular Lime
detergent.
Slight Traces of condensed water on the inside of the
Collector tube does not affect the operation of the
Solar-Fizz.
The Solar-Fizz should be transported or stored without
water only.
In Case of defective Parts, use only genuine Solar-Fizz
Parts. Those can be ordered as well as the below shown
popular options trough:
www.solar-fizz.ch
Page 4
1
2
You can adopt the Solar-Fizz on a
concrete or a wodden plate.
To drill the holes, please use the
enclosed schematic drawing.
Please make sure to align the
collector as accurately as possible to
the midday sun.
Please make sure that no shade from
trees or buildings falls on the collector.
The Solar-Fizz uses 4 Bolts to be screwed onto any
concrete plate. (6mm)
Setup 1
Lift the Solar-Fizz carefully our of the the cardboard
and set flat to the ground.

Page 6
Start-up
Take of the protection foil from the tube collector.
Shut the cold and hot water valves fully.
(in Clockwise direction)
Connect you cold water garden hose to the mixing
battery. (½“ inch adaptor)
Open the cold water garden hose valve.
(appr. 1 turn)
Open the hot water mixing battery valve (red) on the
Solar-Fizz.
Important: The cold water valve (blue) on the Solar-Fizz
must not be opened at this time.
Wait until the water comes out of the flexible shower.
This can take up to 10 minutes.
Shut off the hot water mixing valve (red) again.
Wait until the water flow from the shower stops.
Your Solar-Fizz is now ready to work for you.
The sun will do the rest for you.
1
–
2 –
3 –
4 –
5 –
6 –
7 –
8 –
Do
not expose yourself under the Shower before you
have adjusted the water temperature.
Since the water temperature can be very hot, you
could take a risk to be burned from boiling water.
Page 5
Setup 2
Screw the shower hose to the mixing tap by hand.
Check thereby whether the seal is inserted.
Hang the shower into the shower holder.
3
Optional Accessory
optionnels
:
Ground anchor
Height adaptable
Showerholder
!! Danger !!

Page 8
Important
The Solar-Fizz should be placed in a sunny spot.
The Solar-Fizz should be not exposed to the sun for long
periods of time, if the shower does not contain water.
Please make sure, that the water hose line to the
Solar-Fizz lays in the shadow of the grass.
Parts of the Solar-Fizz can be damaged, if they are misused.
Please handle the Solar-Fizz with Care in order to avoid any
possible damage to the hardware.
www.solar-fizz.ch
!! You could risk your Life !!
Please avoid using the Solar-Fizz
during Thunder Storms
Note:
Do NOT use the Water from the Solar-Fizz as drinking water.
If you do not use the Solar-Fizz for more than 3 days, please
change the Water in the Tubes. To do this, please open the
Hotwater Valve (RED) and let the hot water flow for about
10 minutes to make sure that all the old water has been
replaced with fresh water.
Check for your local use-water regulations .
Page 7
Storage
Go the opposite direction in order to
prepare the Solar-Fizz for the new Season.
!! Do not break or fold the plastic tube !!






1
2
3
1
3
2
Please connect the proper
colored tubes to the nipples
Use controlled
force to do this
To store the Solar-Fizz during the Winter:
Remove the fresh water supply, and unscrew the
blue nipples on the bottom at the Collectors.
Pull off the flexible plastic tube in a 30 degree
angle to the nipples. (See figure 1 + 2 + 3)
Opening the two valves of the mixer.
(The water now flows from the Collectors)
Leave
opened
the valves
.