6.Connection
⑴ Connecting SDI IN/HDMI IN interface of FLOW10K transmitter with SDI OUT/HDMI OUT interface of
camera or video output device. Connecting SDI loop out interface of FLOW10K transmitter with SDI IN
interface of monitor or switcher.
5. Pairing
Interface changing
a ：Changing interface in transmitter via using joystick(left and right),see fig .7、8、9.
b : Changing interface in receiver via using joystick(left and right),see fig .7、9.
MULTI
CAST
ON
OFF
PREF.
HIGH
QUAL
WALL
THRU
FIRM-
WARE
YES
PAIR
YES
Fig.7 Fig.8 Fig.9
Fig.10
One to multi mode High quality mode Firmware upgrade
Pair
Wall through mode
OFF
ON
Tips:
1. The menu content of transmitter and receiver is different: Quality mode and wall through
mode can only be selected in transmitter, see fig.8
2. The“MULTI CAST” should change to“ON” in both transmitter and receiver to open one-to-multi
mode.(Both transmitter and receiver need to choose “MULTI CAST ON”)
3. Support firmware upgrading via USB interface.
4. Both transmitter and receiver support manually switch frequency channel.
5. Factory setting is “MULTI CAST OFF”.
6. Choose “MULTI CAST ON”(The transmitter need to pair with every receiver before using
one-to-multimode）
⑴ Switch on both FLOW10K transmitter and receiver; The “POWER” indicator light in every
receiver should light up when there are multiple receiver, Waiting for jumping to main interface.
⑵ Right pushing the joystick to “PAIR” interface and choose “YES” in both transmitter and
receiver, the“LINK”indicator flashing quickly during pairing(Every receiver should pair with
the transmitter separately when using one-to-multi mode) .
⑶ “LINK” indicator will stop flashing after pairing successful. Device in encrypted transmission
state.
FIRM-
WARE
YES
PAIR
YES
1. Transmitter and receiver should pair in the same time. Every receiver should pair with
the transmitter separately when using one-to-multi mode.
2. Make sure every receiver have already paired successful before using one-to-multi mode.
3. The paired receiver and transmitter, automatically connected after boot, no need to
pair again.
4. Keep 1-2 m distance between transmitter and receiver when pairing to avoid pairing
failure.
5. Do not using more than 4 group wireless transmission device to avoid disturbing.
Tips:
