Symbol TC70 User manual

6
5
8
1
2
3
7
12
20
18
23
19
16
21
17
22
4
13
14
11
15
9
10
Notifications
Charging\Notification LED:
Data Capture LED:
Slow blinking amber: Battery charging
Solid green: Fully charged
Fast blinking amber: Charging error
Slow blinking red: Charging aged battery
Solid red: Fully charged aged battery
Fast blinking red: Charging error aged battery
Slow blinking blue: Application notification
Green: Good Decode
Data Capture
Charging/Notification
Note: Remove protective shipping film that covers the touch screen, exit
window and camera window before using.
FEATURES CARD INSTALLATION
MicroSD Card Installation (Optional)
TC70
QUICK START
GUIDE
1 PTT Button (programmable)
2 Scan Button
3 Back Button
4 Home Button
5Power Input
6 Search Button
7 Menu Button
8 Touch Screen
9 Light Sensor
10 Proximity Sensor
11 Power Button
12 Receiver
13 Charging/Notification LED
14 Data Capture LED
15 Front-facing Camera
16 Hand Strap Mounting Point
17 Camera Flash
18 Rear-facing Camera
19 Interface Connector
20 Exit Window
21 Volume Button
22 Battery Release Latch
23 Hand Strap
Note 1: To reset the TC70, press and hold the Power button until the menu
appears and then select Reset.
HANDSTRAP AND BATTERY INSTALLATION BATTERY INSTALLATION
Red: Data capture in process
1. Remove hand strap filler plate.
2
3
4
BATTERY INSTALLATION
1. Insert the bottom of the battery into the battery compartment.
1. Lift the access door.
2. Insert the microSD card into the card holder. Push the card all the way into the
card holder.
NOTE :
Proper position of the microSD card — the card connector (i.e., gold contacts) should
be facing down.
3. Replace the access door. Ensure that it is properly seated.
4. Rotate the battery down into the battery compartment and press the battery
down until it snaps into position.
2. Insert the hand strap plate into the handstrap slot.
3. Insert the bottom of the battery into the battery compartment.
5. Place the hand strap clip into the hand strap attachment slot and pull down to lock into
place.
2. Rotate the battery down into the battery compartment.
3. Press the battery down until it snaps into position.
Blue: Application notification
6. Lift the hand strap ribbon off the hook material.
7. Slide the pad and adjust the ribbon for best fit.
8. Press the ribbon down to secure to hand strap.

AVOID EXTREME
WRIST ANGLES
Symbol® is a registered trademark of Symbol Technologies, Inc. All other
trademarks and service marks are proprietary to their respective owners.
© 2014 Symbol Technologies, Inc. All rights reserved.
MN000976A01 Rev. A — October 2014
Imaging Camera Photo
1. Touch > Camera.
2. Point the TC70 at an object.
3. Touch the on-screen shutter button.
Symbol Technologies, Inc.
One Motorola Plaza Holtsvilee, NY 11742-1300, U.S.A.
ACCESSORIES DATA CAPTURE OPTIONS
AVOID EXTREME WRIST ANGLES
1. Press the Power button until
the menu appears.
2. Touch Power Off.
3.If installed, unlatch the hand
strap. Push the hand strap clip
up toward the top of the TC70
and then lift.
4. Press the battery release
latches in and lift the battery
from the TC70.
1. Ensure that an application is open and a text field is in focus
(text cursor in text field).
2. Point the exit window at the bar code.
3. Press and hold the Scan button.
4. The red laser aiming pattern turn on to assit in aiming.
When the TC70 decodes the bar code the Data Capture LED
light green and a beep sounds.
5. Release the Scan button.
For more information, see the TC70 User Guide and the TC70 Integator
Guide available at: http://www.motorolasolutions.com/support.
BATTERY REMOVAL
5-Slot Charge Only Cradle
Holster
Magnetic Stripe Reader Charging Cable Cup
4-Slot Battery
Charger
2-Slot Charge
Only Cradle
5-Slot Charge Only Cradle
with Battery Charger
5-Slot Ethernet Cradle
2-Slot USB/Ethernet Cradle
Snap-On USB Cable
Audio Adapter
Battery
Charger Adapter
Stylus
with Tether