Symbol LS 9208 Manual

Setup Instructions for
Verifone Ruby Supersystem
LS 9208

LS 9208 Setup Instructions
2
Introduction
This document provides instructions on programming the Symbol LS 9208 scanner for use with a Verifone Ruby
Supersystem.
Note: Symbol offers a "Ruby Ready" LS 9208 kit (part number LS9208-C14R2800S), which contains an LS 9208
pre-configured for the Verifone Ruby, plus the appropriate Verifone Ruby cable.
Required Hardware
There are two possible connections for this system:
1. Powered from the Ruby and depends on the application to have the register supply power to the scanner
(recommended).
•Cable
• 25-65648-20 (Verifone Ruby TTL/RS-232, 9ft, Coiled).
2. Powered from an external power supply (does not depend on the register to supply power).
•Cable
• 25-60262-20 (RS232 Cable, True TTL, DB9 Female, TxD on 2, 6 ft. Straight), or
• 25-60262-21 (RS232 Cable, True TTL, DB9 Female, TxD on 2, 8 1/2 ft. Coiled).
• Adapters
• 13641-01 (from Verifone), and
• 13836-01 (from Verifone)
• Power Supply
• 50-14000-008 (110VAC for North America), or
• 50-14000-009 (220VAC for Europe and Asia), or
• 50-14000-010 (100VAC for Japan)
Scanner Setup
The following parameters need to be set:
•SetDefault
• Standard RS-232
• Baud Rate 1200
•8-Bit*
• 1 Stop Bit*
• Parity None*
• RTS/CTS Option 3
• Check Parity*
• Convert UPC-E to UPC-A
• Symbol Code ID Character
• Scan Suffix
• Scan Options.
* Already set by default

3
Scan the following bar codes in numerical order to configure the LS 9208 scanner:
1
Set Defaults
2
Standard RS-232
3
Baud Rate 1200
4
RTS/CTS Option 3
5
CONVERT UPC-E to UPC-A

LS 9208 Setup Instructions
4
6
Symbol Code ID Character
7
Scan Suffix
8
1
9
0
10
1

5
11
3
12
Scan Options
13
<Data><Suffix>
14
Enter

LS 9208 Setup Instructions
6
73-60833-SI01
Revision A - September 2004
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, N.Y. 11742-1300
http://www.symbol.com