SYNBIOSIS Protos 3 User manual

Protos 3 - Chromogenic ID - Batch set-up
Quick Guide
3
1
2Position plate
6
Click New BatchClick
Choose batch type
Select Select Chromogenic Media
1Start Protos 3 software
Run Protos 3
Click
Insert the plate holder, ensuring the
plate holder which is recommended by
the software is used
Place plate onto plate holder
5
Defaults are Circular plate 90mm
Change if necessary
Plate configuration
Click
Create batch
4
Enter a Plate ID
Enter
Enter a plate ID found on Measure
tab. Autoincrement default is “on”, to
change this click on the Configuration
tab
Click

2
7
Click
CONTACT SYNBIOSIS:
EUROPE:
Email: [email protected]
www.synbiosis.com
Protos3CBQG
S
Y
N
B
I
O
S
I
S
A D I VI S I O N O F TH E S Y N O P T IC S G R O UP
Accept batch
Protos 3 is now ready to make the first measurement
Enter Name the Batch
Save the batch