Systemline SN1210 Programming manual

Q16761-IS_r4
Quick start instructions
S7 NetConnect
S7 NetConnect - Hi-Res Network Amplifier SN1210
Advanced instructions available on the systemline website: www. systemline.co.uk
Step 5
If set to master mode, set your Time Zone using the dropdown box and press save.
If set to Slave mode, there is no option for time zone. Press save.
Step 6
Download and install Systemline 7 app on your device. You should see your renamed
NetConnect is ready to use.

1) To router, switch
or powerline
2) To speakers (left and right)
3) To power supply
NetConnect pack contents
1 x NetConnect amp
2 x IMO speaker connectors
1 x Power supply
1 x Mains cable
1 x Quick start instructions
Description
This quick start guide is for a system using NetConnects only. If you are using an S7
NetServer all NetConnects should be set to slave mode.
Step 1
Make connections in order shown below.
During setup only one NetConnect should be connected to the network.
Step 2
Open a web browser and type //netconnect into the address bar to open quick setup.
Step 3
Set NetConnect mode to master using drop down box.
Only one NetConnect in your system should be set to master mode. Set the rest to slave
mode.
Step 4
Enter your Zone Name into the box (Kitchen, Dining etc).