TACSWAN 85-028 User manual

QUICK START GUIDE
P/N 85-028 | 85-029
CS CAMERA FILTER SYSTEM &CS CAMERA FILTER SYSTEM &
CS CAMERA PHOTOGRAPHY SYSTEMSCS CAMERA PHOTOGRAPHY SYSTEMS
QUICKLY MOUNT A VARIETY OF FILTERS ONTO CAMERA
LENSES UP TO 82 MM
MOUNTING CAMERA LENS
ADAPTOR TO CAMERA
1.Pull the spring-loaded grip ring until it's wide
enough to fit over desired camera lens.
2.Release the spring-loaded grip ring so that
it's securely attached to camera lens.
PUTTING FILTER INTO FILTER
HOLDER
1. Slide 4 in / 100 mm filter of choice into
the slot of the filter holder. Use care when
sliding filter into holder to avoid damage to
the filter.
2. Repeat with a different filter on separate
filter holder if desired.
ATTACHED FILTER HOLDER TO
CAMERA LENS ADAPTOR
1. Note the four spring-loaded tabs on
mounting side of filter holder.
2. Press the filter holder firmly onto the
raised grooved ring of the camera lens
adaptor until it clicks in place. Be sure it
is firmly attached prior to use to avoid
damage to filter.
3. NOTE: you can stack additional filter
holders on top of one another by
repeating step 2 above.

2
WHAT'S INCLUDED
1. Filter Holder, P/N 51-016
2. Camera Lens Adaptor, P/N 60-185
GENERAL MAINTENANCE
TIPS
• As needed, wash the Filter Holder
and Camera Mount with a soft
washcloth, clean water, and mild
soap. When done, pat dry with a
soft cloth.
• There are no user serviceable
components to this product.
Contact FoxFury for additional or
replacement components
ONE YEAR WARRANTY
Tac Swan, LLC warrants this product
to be free from defects in material for
one year after purchase.
This warranty is given only to the
original end user of the accompanying
product. If you purchased a
product from someone other than
an authorized Tac Swan reseller/
distributor or if the product was used,
(including but not limited to demo
models, show models or refurbished
product by someone other than Tac
Swan) prior to your purchase, you
are not the Original Purchaser and
the product that you purchased is
not covered by this warranty. This
warranty is VOID if this Product has
been altered or modified in any way
(including but not limited to attempted
warranty repair without authorization
from Tac Swan and/or alteration/
removal of the serial number).
THIS IS THE ONLY WARRANTY,
EXPRESSED OR IMPLIED,
INCLUDING ANY WARRANTY OF
MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE.
INCIDENTAL, CONSEQUENTIAL
OR SPECIAL DAMAGES ARE
EXPRESSLY DISCLAIMED EXCEPT
WHERE SUCH LIMITATION IS
PROHIBITED BY LAW.
You may have other specific legal
rights which vary by jurisdiction.
Retain your receipt for proof of
purchase.
CONTACT TAC SWAN
TAC SWAN, LLC
Vista, CA USA
Te l : 760.500.6094
Web: www.TacSwan.com
All Tac Swan products are designed in Oceanside,
CA. All Tac Swan products are manufactured
with the highest quality USA and foreign parts.
Products are assembled in either Tac Swan’s
controlled plant in Asia or the USA, under strict
quality control.
WARRANTY AND OTHER INFORMATION
07/2020