Tactical Power Products 13.5Vdc 3.5A ECO Series User manual

13.5Vdc 3.5A ECO Series
Installation Manual
MODELS :
TPS13-3.5DC
© 2020 The contents of
this manual are copyright
and may not be reproduced
without the written
permission of Tactical
Power Products Pty Ltd.
Security Power Supplies

DANGER
HIGH VOLTAGE
CAUTION
CAUTION
CAUTION
Dangerous Voltages Inside !
No user serviceable parts inside
Do not remove covers
Dangerous internal voltages exceeding
380 Volts - DO NOT REMOVE COVERS !
Equipment must be installed & serviced
by suitably qualied service personnel in
a restricted access area.
TPS13-3.5DC_RevB.pdf www.tacpower.com.au
General
The TPS-13-3.5A power supply is designed for ITE and indoor use only
TPS13-3.5DC model is Dual Channel Switch Mode power supply providing 13.5Vdc at 3.5A continuous load current.
When operating from mains, these models provide an output of 13.5Vdc ( to power connected equipment) and are congured with a
separate battery charging channel. Available battery charge current is 300mA @ 13.5Vdc (total supply output current 3.8A )
Output short-circuit and overload protection are provided . Removal of the fault / short circuit condition will return the power supply
to normal operation ( Auto-Reset ).
TheTPS13-3.5DC power supply has been tested to AS/NZS60950.1:2015 electrical saftey and AS/NZSCISPR32:2015 Class B EMC in Australia
by Austest Laboratories which is a NATA accredited laboratory. A certicate of compliance has been issued by SAA Approvals, Certicate
of Compliance SAA203368-EA.
Metal Cabinet Variants
TPS13-3.5DC Single 3.5A Output + battery charger, supply only - no cabinet (225L x 120W x 60H )
TPS-SMALL KIT Small steel enclosure ( 250W x 310H x 100D mm ) will house 12V 7AH SLA Battery and 1 PDM
TPS-MEDIUM KIT Medium steel enclosure ( 340W x 436H x 145D mm ) will house 12V 17AH SLA Battery and 2 PDM
TPS-LARGE KIT Large steel enclosure ( 480W x 470H x 185D mm ) will house 12V 55AH SLA Battery and 2PDM
All enclosures are supplied with mounitng hardware, tamper switches and battery leads.
Connection
Single Output Models
10-way removable terminal block provides the following:
( See over the page for a layout )
* 13.5Vdc Output
* 13.5Vdc Charger for SLA (Sealed Lead Acid) Batteries
* AC OK Relay Output (Relay is NC when mains is OK)
* Battery Fault / Low Battery Relay Output ( SPDT )
(This relay is NO when Battery is OK, going NC when Battery
voltage drops below approx. 10.5V during AC Fail)
Caution when handling batteries:
Exercise care when terminating and connecting batteries. Mishandling or short circuit of SLA batteries can cause severe damage and re.

K
Rear View
J
AAC Mains OK Output ( NO / COM / NC ) BBattery Low / Fault Output ( NO / COM / NC )
C- Battery + (Connect Sealed Lead Acid Battery) D- Output 13.5Vdc + ( Connect to load or PDM )
EMains OK LED ( Green ON = OK ) FNot Used
GBattery Fuse HReverse Battery LED ( Red ON = Fail )
IBattery Fail Low Battery LED ( Red ON = Fail ) J240V IEC Mains Socket
KCompliance / Date of Manufacture Label
LAYOUT
www.tacpower.com.au
TPS13-3.5DC_RevB.pdf
A B C D
I J K
L M
TPS13-3.5DC Module Front Face
NO CO NC NO CO NC - + - +
E
F
H
I
G

Specications : ( In the interests of product improvement, Tactical reserves the right to change specications without notice)
Eco Range TPS13-3.5DC
Output Voltage 13.5 Vdc
Output Current 3.5A Continuous
Output Channels 1
Output per Channel 3.5A
Input Voltage 240 V ac ( +6% / -10% ) 50Hz
Input Current 1A @ full load
Input In-Rush Current <20A ( 25C cold start up )
Battery Charger 13.5Vdc / 300mA (Max)
Low Battery Indicator 1 x SPDT relay & Red LED
AC Input Indicator 1 x SPDT R 1 x SPDT relay & Green LED elay & Green LED
Weight 668g
Dimensions 225 L x 120 w x 60 H
Overload Protection Hysteretic thermal shutdown with automatic fault recovery
Load Regulation < 1% from open to full load
Line Regulation < 0.2%
Output Ripple <125mV p-p @ full load (Typical)
Working Temperature 0 - 40C without derating
Revision B
Warranty 3 Years
Safety Standards Safety Standard AS NZS 60950.1:2015 Certicate of Compliance SAA 203368-EA
EMC Standards AS/NZS CISPR 32:2015 ( Class B Conducted and Radiated )
Tel: [phone] PO Box 90 Kurrajong NSW 2758 [e-mail]
Securing Your Power Needs ®
Now and into the Future . . .
www.tacpower.com.au
TPS13-3.5DC
The TPS-13-3.5A power supply is designed for ITE and indoor use only.
TPS13-3.5DC model is Dual Channel Switch Mode power supply providing 13.5Vdc at 3.5A
continuous load current. When operating from mains, these models provide an output of
13.5Vdc to the load channel and is tted with a separate 300mA battery charging channel. Providing a total supply output current
3.8A. Output short-circuit and overload protection are provided . Removal of the fault / short circuit condition will return the power
supply to normal operation ( Auto-Reset ).