talech Ingenico iCMP User manual

iCMP Device Setup
Powering Up
1
Enable Bluetooth™ on your iPad
Tap on the Settings app on your iPad,
select Bluetooth from the le menu and
turn the Bluetooth setting ON.
Power on the iCMP
The power button is located above the USB
charging port on the right side of the device.
Before pairing your iCMP with the iPad,
make sure you charge your iCMP device for
a minimum of 3 hours. A full charge takes
about 6 hours.
Settings
Micro USB charging port is
located on the right side of
the iCMP device, below the
power button
| Apple Pay is a registered trademark in the United States and other countries
Thank you for choosing talech and the Ingenico iCMP device.
This guide shows you how to set up, pair and configure your iCMP device and begin taking payments right
away. If you have any questions, you can contact talech support at [email protected]om or 888.995.1998.

Pairing your Device
Pairing your Device (continued)
1
2
Select iOS Pairing Mode
When BT Pairing Required appears on the
screen, select “Begin”.
Select your iPad
Use the green key to select your iPad
from the list.
Find your iPad
Use the F2 and F3 keys to find your iPad
in the list of devices available for pairing.
Get your pairing PIN
The iCMP Bluetooth device name and pairing
PIN should be displayed on the screen.
BT Pairing Required
Register 1 iPad
Register 2 iPad
Register 3 iPad
BEGIN
Register 1 iPad
Register 2 iPad
Register 3 iPad
BT Name: iCMP-20197333
PIN: 12389900
BT Pairing...
Pairing the iCMP with your iPad
iCMP Configuration

Pairing your Device (continued)
Pairing your Device (continued)
3
iPad Settings
Select the iCMP device from the Bluetooth
device list on your iPad.
Pairing PIN
Enter the pairing PIN on your iPad.
Your iCMP device should be paired with your iPad
4
talech Settings
Select the Ingenico iCMP reader from the
card swiper setting screen in the talech app.
talech Payment Process
Tap Pay and you should see a prompt to
swipe or tap to pay using the iCMP reader.
Pairing the iCMP with your iPad
iCMP Configuration

www.talech.com/support1.888.995.1998 [e-mail]
Unpairing the iCMP with your iPad
iCMP Configuration
Unpairing the iCMP
Using Apple Pay™
+
+
iPad Unpairing
Go to Bluetooth under settings, Tap the info
icon on the far right (circle with an i) next to
the Ingenico device. Tap Forget This Device
then OK on the confirmation screen.
iCMP Unpairing
With the iCMP reader
powered on, press the
black “F” key four times
in quick succession. Your
iCMP should be unpaired
with your iPad.
To pay using a default card:
Hold iPhone within an inch of the contactless reader with finger
held on Touch ID without pressing it. Wait for slight vibration, a
check mark on screen and a beep for confirmation of payment.
Wait for payment to be approved and continue with closing the
transaction.
To pay using a dierent card:
Hold iPhone near the contactless reader without placing finger on
Touch ID. iPhone will wake up, and you will see your default card on
screen. Tap default card. From the list of cards, tap the one to you
want to use. Place finger on Touch ID and move iPhone near the
reader to complete the payment.
Contact Us:
| Apple Pay is a registered trademark in the United States and other countries