Tannoy CMS6 TDC User manual

MODEL WITH TRANSFORMER
(SEE FIG. 2)
The RED and BLACK wires are connected
to the transformer as follows:
The BLACK lead to the transformer
primary "common" lead. The RED lead is
connected to the desired wattage tap.
WITHOUT TRANSFORMER
The RED wire connects to the crossover
terminal with the red dot. (Positive termi-
nal). The BLACK lead connects to the
unmarked terminal. (Negative terminal).
INSTALLING THE SPEAKER/SUB
PLATE ASSEMBLY
After connecting the RED and BLACK
leads to the speaker/sub assembly can
be attached to the enclosure.
Fasten the sub plate to the enclosure by
inserting the silver screws in the holes
labeled 1, 2, 3, and 4, as shown on Fig. 1.
The four remaining holes are used to
fasten the grille to the enclosure. Use the
white painted screws provided. Do not
over-tighten screws. Removable locktite
on these screws is recommended.
Note: A tile bridge is required for most
applications.
CMS6 TDC ASSEMBLY INSTRUCTIONS
FIGURE 2
335 GAGE AVENUE, SUITE 1, KITCHENER, ONTARIO CANADA N2M 5E1
PHONE[phone] • FAX[phone] • E-MAIL: [e-mail]
CAN DIA.
11
7
/
8
" 300mm
12
3
13
1
/
4
" 335mm
MOUNTING FLANGE DIA.
TO BOX INSTALLED
9
5
/
8
"
246mm
7
5
/
8
"
194 mm
MOUNTING
FLANGE
CAN
EXTENSION
7
/
16
" 11.5 mm
12" 305mm
HOLE
CUT OUT DIA.
FIGURE 1
4