Tatung KDRC-48 User manual

COMPONENTS HARDWARE
A
cam bolt x 12
B
cam x 12
C
cap x 12
D
screw x 16
E
tool x 1
F
wood dowel x 4
STEP 1
A
cam bolt
1
24
5
5
F
wood dowel
STEP 2
TATUNG UTILITY CENTER CABINET
ASSEMBLY INSTRUCTION
MODEL: KDRC-48
G
G
glue x 1
Securely screw cam bolt (A) into
left panel (1) and right panel (2). Apply glue (G) on holes for wood dowel and insert wood dowel (F) into part (5).
Attach part (5) to top shelf (4).
glue
1
2
34
6
5

STEP 5 STEP 6
STEP 3 STEP 4
4
6
2
2
4
6
1
cam
B
C
cap
STEP 7
D
screw
3
E
tool
Apply glue (G) on hole for wood dowel.
Attach top shelf (4), bottom shelf (6) and
part (5) onto right panel (2) by aligning
each cam bolt and wood dowel to its
corresponding hole.
Apply glue (G) on hole for wood dowel. Attach
left panel (1) onto bottom shelf (6), top shelf (4)
and part (5) by aligning each cam bolt and wood
dowel to its corresponding hole.
Insert cam (B) into hole in top shelf (4) and
bottom shelf (6) with notch of cam facing head
of cam bolt (A). Tighten cam (B) approximately
1/2 turn clockwise until snug by using tool E.
Press cap (C) into cam(B).
NOTE:
Using an optional 5/16" slotted screwdriver has
the best result to turn the cam (B).
Turn partially assembled cabinet to standing
position. Attach back panel (3) by tightening
screw (D) into the pre-drilled holes.
5
5
Carefully place a refrigerator into the assembled
cabinet.
6
4
G
G