
18.This appliance is not intended for used by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliances by a person
responsible for their safety.
19.Always operate the appliance with
cover in place.
20. Never place this appliance on or near a hot
gas or an electric burner or where it could
touch a heated appliance.
21.This appliance is intended to be used in house-
hold and similar applications such as:
– Staff kitchen areas in shops, offices and other
working environments;
– Farm houses;
– By clients in hotels, motels and other residen-
tial type environments;
– Bed and breakfast type environments.
22.Children should be supervised to ensure that
they do not play with the appliance.
23.The appliance shall be used with the
stand provided
24.Do not use outdoors.
25.Save these instructions.
BEFORE THE FIRST USE
The appliance can be used for finishing the following
tasks separately: I. frothing and heating milk; II. only
frothing without heating; III. only heating, without
frothing.
1. Before using your milk frother, clean all the parts
according to the section under “CLEANING AND
MAINTENANCE”.
2. Important: do not wash any parts in the dishwash-
er, and do not immerse the jar in water.
3. This may permanently damage the product and
void the warranty.
4. The appliance is equipped with two accessories
- mixing paddle and frothing paddle, the mixing
paddle is used for mixing milk during heating to
prevent from sticking. The frothing paddle is used
for frothing milk during heating or is used for
frothing separately, but no heating. Select desired
accessory according t
o your task.
NOTE: the max capacity of the jar is 450ml.
OPERATION OFYOUR MILK FROTHER
Frothing and
1. Place the appliance on a flat surface.
2. Select frothing paddle, then open the lid and
insert the frothing paddle onto the shaft on the
bottom of jar.
3. Fill the jar with the desired amount of milk (To
ensure good result, it is recommended the initial
temperature of milk shall be 10-15˚), and
replace the lid.
NOTE: the max milk quantity permitted to add is
100ml, to avoid milk overflowing after frothing.
4. Place the jar on the power base and connect the
plug into a power outlet, the indicator
will light red.
5. Press the switch button once, the indicator will
light blue. Then the appliance will start to work.
Once the temperature of milk has achieved about
58-78˚, the heating element will stop heating and
the frothing paddle will stop rotating automati-
cally; the indicator will illuminate red again until
unplugging the power outlet.
Note: During operation, you can stop operating
by pressing the switch button once.
6. When the appliance has stopped operating, pour
out the warmed and frothed milk from the spout
to enjoy it.
Caution: Minimum 3 minutes rest time must be
maintained between two continuous cycles, oth-
erwise, the appliance will enter the self-protection
state automatically after working for 5 cycles
continuously, the indicator will be illuminated blue
and flash, the switch button will not be activated,
after about 5 minutes, the appliance will enter
standby tate and you can continue
operating the appliance.
7. Always turn off the milk frother and disconnect
the power supply when not use.
Only frothing without heating
1. Follow steps 1-4 in the section under
“Frothing and heating”.
2. Press the switch button three times continuously
within 2s, the indicator will illuminate blue and
blink, the frothing paddle will rotate for frothing
milk separately, but the heating element will not
heat. And the appliance will automatically stop ro-
tating after operating, the indicator will illuminate
red again until unplugging the power outlet.
Note: During operation, you can stop operating
by pressing the switch button once.
3. When the appliance has stopped operating, pour
out the frothed milk from the spout and enjoy it.
Caution: Minimum 3 minutes rest time must be
maintained between two continuous cycles, oth-
erwise, the appliance will enter the self-protection
state automatically after working for 5 cycles
continuously, the working indicator will flash and
the switch button will not be activated, after about
5 minutes, the appliance will enter standby state
and you can continue operating the appliance.
4. Always turn off the milk frother and disconnect
the power supply when not use.
Only heating without frothing.
1. Place the appliance on a flat surface.
2. Select mixing paddle according to your task. Then
open the lid, insert the mixing paddle onto the
shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk (To ensure
good result, it is recommended the initial tempera-
ture of milk shall be 10-15˚), and replace the lid.
NOTE: the max milk quantity permitted to add is