Team Magic E4D User guide

Not Included
AA
1Tramsmitter Function 2Operating Procedure
01
02
Install 8pcs AA batteries to the H.A.R.D. transmitter.
Insert the antenna wire into the tube as shown.
Fasten the tube with a set screw and put on the
tube cap.
03
Thumb nuts are used to fasten the battery
holder. Use appropriate charger to charge
the included receiver battery pack.
04
Turn on the transmitter first.
05 06
Connect the battery pack to the speed controller. Finally, switch on
the speed controller power.
H.A.R.D. Dual Mode Speed Controller is the most advanced speed
controller at the market. There are two modes available: Gentle &
Fierce.
Gentle Mode: Yellow Indication Light (50% output)
Fierce Mode: Red Indication Light (100% output)
After switch on, the speed controller will auto-reset the throttle
neutral position within 5 seconds with beep sound. Push the button
for 3 seconds on the speed controller to switch the mode.
Rotate the transmitter wheel for left and right.
Pull the trigger for acceleration and push the trigger for brake and
reverse.
Switch
Mode Switch Button
Switch
LED Light
Red 100%
Yellow 50%
!Notice there is
a small space for
wire to go through. !
Optional The cushion
foam usage depends
on the battery type.
Steering Wheel
Tum model to left or right
Throttle Trigger
Control the speed of the
model and movement
forward and backward
Steering Trim
Adjusts the steering in small
increments so the model will
run straight.
Battery Level
Indicator
If the Red led flashes , replace
batteries.
Power Switch
When slid upward,the power
is turned on.
TH Servo
Reversing Switch
ST Servo
Reversing Switch
Throttle Trim
Adjusts the throttle in small
increments so the model will
not move at neutral
Antenna
Instruction & Setup Manual

Parts List
PARTS
503206
503115
503117
503120
503125
503127
503130
503138
503140
503141
503144
503145
503152
503155
503156
503163
503169
503180
503183
503191
503196
503197
503202
503203
503205
503210
503212
503213
503214
503215
503218
503222
503224
503226
503236
503250
503251
503252
503253
503254
503255
503257
503258
503259
503260
503263
503264
503265
503267
503268
503269
503270
503271
503272
503273
503274
503275
503276
Hinge Pin Ball(POM)(4)
Front Rear Hinge Pin Mount Set
5x4mm Ball Stud (6)
Hinge Pin Mont Nylon Ball Cap (4)
Front Steering Block Set
Steering Block 5x10mm Ball Stud (4)
Front Lower Outer Hinge Pin (2)
5x7mm Ball Stud (6)
Long Ball Cup (6)
Middle Shaft Mount
Pulley O-Ring 7x2mm (10)
Bumper Post Set
Rear Hub Carrier (2)
Ball Diff Pulley 35T
Ball Diff Steel Ball 2.5mm (12)
Spur Gear 110T
Main Shaft Upper Mount Set
Shock Spring Mount & Ball Cup (4)
Shock Spring (2)
New Shock Bladder (4)
Lightweight Front Bulkhead Upper Mount
Lightweight 17T Side Pulley
Front Lightweight Ball Diff Outdrive Set
New Ball Diff Plate (2)
Rear Lightweight Ball Diff Outdrive Set
Single Bell Crank Steering System
New Wide Side Belt
New Caster Block Ball Stud (4)
Caster Block Lower Screw (4)
Lightweight Caster Block Set (6 degree)
Lightweight Rear Front Hinge Pin Mount
Nylon 18T Center Pulley
Lightweight Rear Bulkhead Upper Mount
Special Servo Disc Ball Cup (2)
Nylon 17T Center Pulley
Shock Set (2)
Front Nylon Shock Tower
3.1x6.5x3mm Nylon Washer (6)
Front Nylon Bulkhead Set
Front Lower Arm Set
Nylon Quick Release Battery Holder
Upper Deck / Belt Tensioner Mount
Belt Tensioner Set
Front Lower Inner Hinge Pin (2)
Lower Nylon Hinge Pin Mount 1.5 Degree
Alum. Middle Shaft
Ball Diff Screw & Spring Set
Rear Lower Outer Hinge Pin (2)
Motor Mount
Rear Nylon Bulkhead Set
Rear Lower Inner Hinge Pin (2)
Nylon Main Shaft Left Mount
Lower Nylon Hinge Pin Mount 2.5 Degree
Alum. 7075 Main Shaft
Spur Gear Holder
Rear Nylon Shock Tower
Servo Mount
Front Chassis
503277
503278
503279
503280
503281
503282
503283
503250-1
503250-2
503250-3
503250-4
503301
503302S
503303
503304
503305
503306
503307
503308
503310
503311
503312
503313
111007ST
111120
111160
115024
116206
116219
116222
126306
126308
126310
130102
130115
150508
150612
150814
151015
151218
126303S
126306BU
126306S
126308BU
126308C
126310BU
126314BU
126318c
126403S
150308TF
H6802
H6803
H6804
H6805
K1005
K6301
K6302
Main Chassis
Rear Chassis
Rear Hub Carrier Nylon Wahser (4)
3.1x6.5x5mm Nylon Washer (6)
Nylon Front Upper Linkage (2)
Nylon Steering Linkage (2)
Nylon Rear Upper Linkage (2)
Shock Cap Set (2)
Shock Shaft & Piston Set (2)
Shock Body Set (2)
Shock Body Hardware Set (2)
Drift Car Nylon Accessories
Drift Car Mounted Tire (5 Spoke, Silver)(4 pcs)
Alum. Front/Rear CVA Shaft (2)
Front Belt
33T Pinion Gear
Bumper Set (F/R)
Front Body Post Set
Battery Holder Screw (2)
Rear Belt
Rear Lower Arm Set
Foam Bumper
Servo Arm (Futaba) (2)
3mm Steel Locknut (10)
R6 R-clip (10)
4mm Special Wheel Lock Nut (4)
4mm Short Thread Ball Stud & Ball Cup (for 3mm rod) (5)
2x10mm Pin (10)
3x6.5x2mm Alum. Washer (6)
3M Double Side Tape 3x13cm
3x6mm Steel FH Screw (6)
3x8mm Steel F.H. Screw (6)
3x10mm Steel F.H. Screw (6)
8.1x12x0.2mm Shim (10)
3x8x1mm Alum. Washer (10)
5x8x2.5mm Bearing (2)
6x12x4mm Bearing (4)
8x14x4mm Bearing (2)
10x15x4mm Bearing (4)
12x18x4mm Bearing (4)
3x3mm Set Screw (6)
3x6mm Steel Button Head Screw (6)
3x6mm Set Screw (6)
3x8mm Steel Button Head Screw (6)
3x8mm Steel Cap Screw (6)
3x10mm Steel Button Head Screw (6)
3x14mm Button Head Screw (6)
3x18mm Steel Cap Screw (6)
4x3mm Set Screw
3x8mm Thrust Bearing Flat (1)
HR132JE 2 Channel AM Receiver 27MHz w/o Crystal
H.A.R.D. HS3003 Throttle Servo
H.A.R.D. JR Dual Mode ESC (w/reverse)
H.A.R.D. X3 Motor
Special 3mm Servo Holding Screw (5)
Black Grease (for thrust bearing as well, 4g)
Ball Diff Lube (4g)
61130