TECALEMIT W85 Manual

GO WITH THE FLOW.
HARDWARE INSTALLATION
GUIDE - W85 DIESEL PUMP
www.tecalemitusa.com I [email protected] Tel: [phone] I Fax: [phone]
Revised: 4/8/2021

INSTALLATION GUIDE
GO WITH THE FLOW.
www.tecalemitusa.com I [email protected] Tel: [phone] I Fax: [phone]
TO ATTACH PUMP TO TANK:
TO CONNECT BRACKET AND PUMP:
1. Connect downtube fitting* [1] to
bulkhead adapter.
2. Connect bulkhead adapter [2] to
bulkhead fitting on tank. Make
sure to use thread sealant (not
included). Connect bracket [3] to
adapter [2].
3. Connect y-strainer [4] to top of
bracket [3]. Make sure to use
thread sealant (not included).
4. Connect pipe extender [5] to top
of y-strainer [4]. Make sure to use
thread sealant.
5. Connect pipe extender [5] to pump
suction [6]. Make sure to use
thread sealant (not included).
6. Connect meter [8] to pump dis-
charge [7] - no sealant necessary.
7. Connect hose [10] to meter [8].
Make sure to use thread sealant
(not included).
• If using a filter, use filter adapt-
er [9] to connect filter housing
to meter (filter housing/filter
not included).
8. Connect swivel [11] to hose [10].
Make sure to use sealant (not in-
cluded).
9. Connect automatic nozzle [12]
to swivel [11]. Make sure to use
thread sealant (not included).
7
5
4
3
1
12
11
10
8
6
9
2
*Rigid 1” MNPT pipe
is recommended for
downtube. Pipe not
included.
Diesel Fuel Only