TECHLIGHTING Ikon 700OSIKN92730 User manual

1.0
Installation Instructions for
Ikon Step Light
700OSIKN92730_
920OSIKN
OUTDOOR
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
This product is suitable for wet locations.
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product can be dimmed with most MLV dimmers (12v only).
120v version is not dimmable.
This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2019 Tech Lighting, L.L.C.All rights reserved.
Visual Comfort Group

2
2
1With the provided Allen wrench, loosen the set screw from the bottom of the fixture base.
Remove the mounting plate from the fixture base.
Install the mounting plate to the junction box with the two #6-32 screws provided and ensure the mounting plate is level.
Connect the red driver output wire to the red fixture wire.
Connect the black driver output wire to the black fixture wire.
Connect the fixture to a suitable ground in accordance with local electrical codes.
For 120v fixtures only: Connect the white wire to the neutral power line with a wire nut.
For 120v fixtures only: Connect the black wire to the hot power line with a wire nut.
For 12v fixtures only: Connect the black driver wires to the black junction box wires (from the remote transformer) with wire nuts.
Properly place all wires, driver and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and
secure it in place by tightening the set screw using the provided Allen wrench.
(Optional):To adjust the CCT, access the CCT toggle on the back of the fixture base loosen the allen screw at the bottom of the fixture.
Then access the back of the fixture base by removing it from the mounting plate. Select the desired color temperature. Then reinstall the
fixture base and secure with the allen screw. It is recommended to do this before applying sealant.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1A
Install the Fixture
4
3
6
5
7
8
ALLEN WRENCH
& SET SCREW
12
9
3
FIXTURE BASE
JUNCTION BOX
DRIVER
1
3
78
11
ALLEN SCREW
CCT TOGGLE
MOUNTING PLATE
6
FIXTURE BASE
JUNCTION BOX
WIRING DIAGRAM
FOR 12V
10
6
TO FIXTURE
5
4
9
9
11
12
WIRING DIAGRAM
FOR 120V