TechVision BTB40W User manual

User Manuel with Installation Instructions
Bluetooth Hidden Speaker System
(BTB40W)
www.techvision.co.uk

Introduction
This system uses Industry Spa Tactile Transducers, connected to a Bluetooth Amplifier,
producing brilliant “Hidden Sound”.
Tactile Transducers work by transferring their energy into the material they are attached to.
As the surface becomes the sound board they work better with dense materials such as
wood and plasterboard. However, we have found good results with Acrylic Baths and
Shower Walls.
Important - Safety Instructions
Before installing the speaker, please read and follow the instructions carefully, provided in
this User Manual.
WARNING - To reduce the risk of fire or electric shock:
install in accordance with the manufacturer’s instructions
do not use damaged power cords or plugs, or loose electrical sockets
do not install this product in Zone 1or 2 of a bathroom or kitchen
do not install this product outside
do not expose the amplifier or plug to water
do not block ventilation openings
do not install near excessive heat sources such as radiators, microwaves, hot
cooking equipment
do not attempt to disassemble, modify or repair this unit, or the power cable.
Please note: any changes or modifications will void your warranty.
If you require a new plug socket for use with this speaker system, it must be fitted by a
qualified electrician.
If you install an isolation switch, then this must be fitted by a qualified electrician.

Specification - Tactile Transducer Speaker (Full Range)
Frequency Range 20Hz – 20KHz
Max Power Output 50W at 8 Ohm
Dimensions 80 diameter*40mm
Specification – Bluetooth Amplifier Spec
Transmission Range 5m to 10m
Max Power Output 2ch * 20W
Voltage 12Volt DC / 4amp
Dimensions (W*L*H) 133 * 88 * 45mm

Installation Guide
Affix the transducer plates to your chosen surface using either epoxy resin or screws.
Fix the transducers to the plates using the fixing bolt provided.
Plug the Red & Black connections into the rear of the amplifier.
Plug the amplifier in and power on. We recommend setting the volume to 70%.
Turn on your music device (phone, etc) and SEARCH for Bluetooth devices. You can now
PAIR to the amplifier.
The plug socket needs to be located in a dry area, i.e., an adjacent room, in the loft or
under the bath. If installing under a bath, a bath panel must be securely fixed.
Volume can be controlled via your phone.
The Amplifier should be located where it can best receive the Bluetooth signal, in a
dry and ventilated area.
If using in conjunction with our Bathroom TV, then connect a cable from the Audio jack
to the Red & White Audio connectors on the rear of the TV.
Other applications:
These waterproof transducer speakers can also be fitted behind ceilings, walls, cupboard
doors, for a truly hidden home theatre experience. No unsightly speakers visible
anywhere!
Home theatre (use in conjunction with subwoofer), museums, exhibits, displays, spas,
message therapy, ceiling tile PA, tactile therapy and many more limited only by your
creativity!
When fixing to a wall, ceiling, etc, the speaker should be screwed to the back of the
substrate, using appropriate fixing screws. As a substrate, we recommend half-inch
plywood for best results.
Box contains: 2x 3” Tactile Transducer Speakers, installation discs and adhesive strips,
Bluetooth Amplifier, power cable & plug and user guide.