Tecno RS User manual

TECNO RS SEATING SYSTEM
WALL MOUNT INSTALLATION INSTRUCTIONS
page 1 of 2 | Rev. 05-05-16
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
STEP BY STEP
Secure wall mount bracket to wall
• Choose hardware that is appropriate
for your application. Mounting bracket
accepts 14mm bolt for mounting (top
hole) and 10 mm bolt for leveling
(bottom hole).
• Use a level to ensure mounting location
is level before securing mounting
brackets to wall.
Note: Because different wall materials
may require different hardware,
mounting hardware is not included.
FOR WALL MOUNT CONFIGURATIONS.
Attach seat rail to freestanding legs
• Once all wall mount brackets are in
position, place seat rail onto brackets.
Ensure that connection holes in the seat
rail and brackets align.
• Insert M12 lock washer (c), then M12
x 120 socket head cap screw (b) into
seat rail to secure seat rail to the rail
mounting bracket.
• Tighten screw until snug.
• Fit nylon cap (a) onto the top of socket
head cap screw.
Secure seat rail
• Seat rail should now be secured to the
wall mount bracket.
TOOLS NEEDED
MATERIALS INCLUDED
a b c
a
b
c
d
Loctite
M8 hex key
M12 hex key
14mm bolt for
mounting
10mm bolt for
leveling
pencil
level

TECNO RS SEATING SYSTEM
WALL MOUNT INSTALLATION INSTRUCTIONS
page 2 of 2 | Rev. 05-05-16
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
STEP BY STEP FOR WALL MOUNT CONFIGURATIONS.
For configurations with backed seats
• Position backed seat on seat bracket
ensuring that mounting holes line up.
• Insert M8 x 35 socket head cap screws
(d) using an M8 hex key to secure
backed seat to seat bracket.
• Tighten screws until snug.
NOTE: Forms+Surfaces recommends
applying Loctite®or similar thread-
locking adhesive.
For configurations with backless seats
• Position backless seat on seat bracket
ensuring that mounting holes line up.
• Insert M8 x 35 socket head cap screws
(d) using an M8 hex key to secure
backed seat to seat bracket.
• Tighten screws until snug.
NOTE: Forms+Surfaces recommends
applying Loctite®or similar thread-
locking adhesive.
d
d
d d