TEFAL QUICK CUP User manual

QUICK CUP
www.tefal.co.uk
GB
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 1

C
J
A
D
E
G
I
H
K
G
I
H
K
H
GB
* Depending on model
*
*
*
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 2

fig.1bfig.1a fig.2
fig.3 fig.4 fig.5
fig.6 fig.7
fig.10fig.9
fig.8
fig.11
on
o
on
o
on
o
on
o
2
2
1
2
12
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 3

Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 4

Thank you for purchasing this Tefal water heater. Please read the instructions common to all of our
models carefully and keep them in a safe place..
Product description (fig. 1)
Rinsing before using for the first time
1 Remove all of the packaging, stickers or accessories from the interior and exterior of the appliance.
2 Remove the tank Aand clean it in water, taking care that no particles remain in the tank.
3 Then fill the tank Awith cold water and reposition it firmly on its base D, making sure that the release
valve C is properly engaged fig 1a,1b and 2.
4 Plug in the appliance.
5 Place a container that holds approximately 1.5 litres under the nozzle E.
6 Hold down the hot water button H: hot water will begin to run out fig 3.
When operating for the first time, it is normal that a little steam escapes from the nozzle E.
7 When the container is almost full, release the hot water button Hto stop the flow. Discard the water.
Installation of the CLARIS filter cartridge
(according to model)
• To get the best taste and performance from your appliance we advise you to use the Claris Aqua Filter
System cartridge. This cartridge contains an anti-lime substance and activated carbon that reduces
chlorine, impurities, lead, copper, pesticides, etc that are present in water. inerals and trace elements,
however, are preserved.
1 Unwrap the cartridge J. Take note of the month in which the cartridge is put into use by sliding the upper
ring on the filter to the use start date fig 4. You should change your Claris Filter Cartridge every 4 to
6 weeks (or every 50 litres), according to the hardness of your water.
2 Position the cartridge in the tank Aand screw the cartridge Ja quarter turn into the bottom of the tank.
Certain models also have an indicator light K, which indicates when it is necessary to change the cartridge.
For these models, when this light Kflashes during use, it is time to change the cartridge fig 5.
3 To change the cartridge, remove the used cartridge and replace it with a new Claris Aqua Filter system
cartridge, sold as an accessory (ref XH 5000) fig 6.
4 For models with an indicator light, it is necessary to record the change of cartridge by simultaneously
pressing the hot water button Hand the ambient water button G, for at least 5 seconds fig 7.
After 5 seconds, the indicator light will go out. The appliance will then have recorded the cartridge change.
• The Claris Aqua Filter cartridge can be installed in all Tefal Quick Cup models, including those that do not
have a filter on purchase.
5
Awater tank
Btank lid
Cwater release valve
Dbody of the appliance
Enozzle or water outlet
GAmbient temperature button
Hhot water button
Iquantity selector (according to model)
Jfilter cartridge (according to model)
Kcartridge change and descaling indicator light
(according to model)
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 5

Getting started
1 Place the appliance on a flat, stable heat-resistant surface away from
water splashes and any sources of heat. Plug the appliance into the mains.
2 After having removed the lid B, remove and fill the tank Awith cold water.
fig 1a and b
3 Put the tank back in place by pressing firmly and reposition the lid B.fig 2.
4 Place the desired container under the nozzle E.
5 Briefly press the hot water button Hand you will automatically obtain
220 ml of hot water fig 8. The water will stop running automatically.
Press again on same button if you wish to stop water before the cycle
comes to an end.
If you would like a greater or lesser amount of water, hold down the
button until you obtain the desired quantity of hot water fig 3. As soon
as you release the button, the hot water stops running.
Follow the same procedure with the the ambient water button Gto obtain
200 ml of water at room temperature fig 9 or fig 10.
If you would like to get ambient water after hot water has been running,
fill half a mug and throw it away or wait 5 minutes as a minimum.
If you would like to get hot water after ambient water has been running,
fill half a mug and throw it away.
6 With certain models, you have the possibility of presetting the amount of
water automatically delivered by the appliance yourself.
To programme the amount for the hot water button H, press both hot
water Hand ambient water Gbuttons simultaneously fig 7. The
indicator light Kflashes to indicate that you are now in programming
mode. Then press the hot water button Huntil you obtain the desired
amount of water in your container fig 3. Finally confirm the recorded
amount by simultaneously pressing buttons Gand H fig 7. The light will
turn off at the end of the programming mode.
To programme the amount for the ambient water button G, follow the
same procedure as for programming the hot water button H, pressing the
ambient water button Gto obtain the desired amount of water fig 10.
7 The models with a quantity selector offer an additional function: you can
adjust the amount of water automatically delivered to your container. To
do this, select the chosen amount on the rotary button I, according to your
container, then briefly press the hot water button Hto obtain hot water
or the ambient water button Gto obtain ambient water; the water flow
will stop automatically fig 11.
8 If you are using small cups, we recommend that you hold the cup close to
the nozzle Eto avoid any splashes.
9 To ensure minimal energy consumption from this appliance please switch
off your plug point when the product is in use.
Descaling your appliance
In order to optimise the lifetime of your appliance, we recommend that you descale it at least every 2 months.
Descaling should be carried out more frequently if you live in a very hard water area.
Certain models also have an indicator light K, which indicates when descaling is necessary. When this
indicator Kis on during use, it is time to descale the appliance.
To descale:
1 Remove the Claris filter cartridge fig 6.
2 Place a container of at least 1.5 litres under the nozzle.
6
- Do not fill the tank with
hot water, milk or any
other liquid.
- ake sure that no
foreign bodies, such as
grit or small particles,
get into the water tank:
any damage arising
from foreign bodies
having entered the tank
is excluded from the
guarantee.
- ake sure that the
water is fresh from the
tap so that it has not
had time to become
stagnant or in contact
with the air and that it
is odour-free.
- Never remove the tank
while the appliance is in
operation.
- If you use an entire
tank of water all at once
(approximately 1.5
litres), let the appliance
rest for 10 minutes
before launching a
new cycle.
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 6

3 Empty the tank A, if it is still full of water, then reposition it on its base fig 2.
4 Pour 1 litre of commercially available white vinegar at 8° into the tank.
5 Press the hot water button Hand the ambient water button Gsimultaneously for at least 5 seconds fig 7.
You have the possibility of launching a descaling cycle even if the indicator light Kis not on. To do this, press
the hot water button Hand the ambient water button Gsimultaneously for at least 10 seconds
6 The descaling cycle thus runs automatically for approximately 10 minutes. The indicator turns off at the
end of the cycle.
7 When the cycle has come to an end, empty the container and refill the water tank to a maximum. Relaunch
a new operation for rinsing the appliance by holding down one of the buttons fig 3 and fig 10.
8 Once this last cycle has finished, reposition the Claris cartridge; your appliance is ready for use once more
fig 6.
Never use any other descaling method than that advised.
Cleaning and maintenance
• Systematically disconnect the power supply cable before any maintenance
operation. Then clean the appliance with a damp cloth.
What to do if there is a problem
IF YOUR APPLIANCE IS DROPPED, LEAKS OR IF THE POWER SUPPLY CORD OR
PLUG ARE VISIBLY DA AGED
Return your appliance to your authorised Service Centre. See the warranty
conditions and the list of centres in the handbook provided with your
appliance.
This product has been designed for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer
accepts no responsibility and the guarantee will not apply.
Problems Probable causes Corrective actions
Appliance makes a strange noise No more water left in tank Fill tank
Tank is incorrectly fitted Press the tank firmly to engage again
Water flows too slowly or not at all Not enough water in tank Fill tank
The tank is not fitted correctly Press the tank firmly to engage again
The appliance is coated with scale Descale appliance
Water is cold The appliance is coated with scale Descale appliance
7
Do not immerse the
appliance in water.
Do not put the appliance
in the dishwasher.
Do not use the appliance.
No attempt must be
made to disassemble the
appliance or safety
devices.
The type and series
number are shown on the
base of your model.
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 7

Important: safety instructions
Note: This appliance does not produce boiling water. Therefore please check any food or beverage instructions
before using this appliance for such things as baby food and drinks.
The hot water from this appliance cannot be used for sterilising purposes. Therefore, please check the
instructions before using this appliance when preparing such things as drinks and food for babies.
• Carefully read the operating instructions before first use of the appliance and keep them in a safe place:
Tefal shall not be held responsible for incorrect use.
• Only connect the appliance to an earthed socket. Check that the power supply voltage shown on the
appliance’s rating plate corresponds to that of your installation.
• Take care not to place the appliance on a hot surface like a hot-plate or use it close to a naked flame.
• Immediately take the plug out from the mains if the appliance does not function correctly.
• Do not pull the power supply cable to remove the plug.
• Do not let the power supply cable hang down on the edge of a table or a work surface.
• Do not place your hand or the power supply cable on the hot parts of the appliance.
• Never soak the appliance, the cable or electrical plug in water or other liquid.
• Keep the appliance out of reach of children and certain disabled persons do not let the cable hang down.
• Do not use the appliance if the power supply cable or the appliance itself are damaged.
• To avoid any danger, do not use the appliance if the power supply cable or plug are damaged. You must
have the power supply cable replaced by a TEFAL authorised service centre.
• Always refer to the instructions to de-scale the appliance.
• Protect the appliance against humidity and frost.
• Do not use the appliance if it does not operate correctly or if it has been damaged. In such an event, you
are advised to have the appliance examined by a TEFAL authorised centre (see list in TEFAL Service
handbook).
• Except for cleaning and scale removal in accordance with the procedures for use of the appliance, any
intervention on it must be performed by a TEFAL authorised centre.
• Any error in electrical connection negates the warranty.
• Disconnect the appliance as soon as you have finished using it for a while or when cleaning.
• All appliances are subject to severe quality inspection. Practical tests using appliances taken at random are
conducted and this may explain any marks showing prior use.
• You are advised not to use multiple sockets and/or extension cables.
Safety limits
This hot water dispenser must only be used with water in the tank. Tefal accepts no responsibility for any
damage resulting from the appliance being used for unauthorised purposes, faulty connections, dangerous
handling, operations and repairs. The maintenance warranty will be void in such circumstances.
This appliance is intended for domestic use inside the home only. It is not designed for commercial or
professional use.
Preventing domestic accidents
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
8
To avoid accidents,
do not carry your child
or baby when drinking
or carrying a hot drink.
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 8

Even slight burns can sometimes be serious for children.
As they grow up, teach your children to take great care with hot liquids they
may encounter in the kitchen. Place the appliance and power cable well
behind the work surface outside reach of children and certain disabled
persons.
If an accident occurs, immediately apply cold running water to the burn and
call a medical doctor if necessary.
Protecting the environment
Let’s all help protect the environment!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point..
For any consumer queries simply call this number:
0845 602 1454 - UK
[phone] - Ireland
or consult our website - www.tefal.co.uk
9
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 9

Réf. 0827787
Notice Tefal GB:Mise en page 1 19/03/07 17:21 Page 10